Samsung SRP-270 Series specifications

Page 12

7). Insert the end of the roll paper into the groove on the Roller-Pulley, warp the paper around it two or three times and load the Roller-Pulley onto the groove of the Case.

8). Push the auto-cutter cover as shown below and close the printer cover.

NOTE : Push upper face of the auto cutter cover for completely locking of it.

9). When the ERROR light is on and PAPER OUT light blinks, please press the FEED button. After that, the printer is ready for printing.

Image 12

Contents Series Introduction Table of Contents Checking the Contents of the printer box Installing the printerUnpacking Functions Connecting the cables Connecting the AC adapter to the printerConnecting Interface Cable and Drawer Cable to the printer Installing the roll paper Ribbon Cassette InstallationRoll Paper Installation Page Page Page Setting the DIP switches DIP Switch 1 Setting Emulation mode selectionDip Switch 2 Setting Baud rate selectionParallel/USB Interface Specification Hexadecimal Dumping Self test Self-test printing Please press the Feed buttonCharacter Test Completed Code Table 0 PC437 USA, Standard Europe International Character Set USA2 PC850 Multilingual 3 PC860 Portuguese 4 PC 863 Canadian French 5 PC 865 Nordic 19 PC 858 Euro International Character Control Commands List Epson modeCitizen mode CanStar mode Control code Hexadecimal Function Code Connectors Appendix aSerial InterfaceRS-232C Serial Communication InterfaceExampleSerial InterfaceRS-485 GND Drawer Connector USB Interface Pin No Signal Name Assignment Function ColorSpecification Appendix BAppendix C Removing Jammed Paper