Samsung SRP-270 Series DIP Switch 1 Setting, Emulation mode selection, Dip Switch 2 Setting

Serial Interface (RS-232C/RS-485) Specification

DIP Switch 1 Setting

SW	FUNCTION			ON					OFF		DEFAULT
1	Emulation Selection			Refer to the following table							OFF
2											OFF
3	Auto-Cutter			Enable				Disable			OFF
4	FONT SPACE			2				3			OFF
5	Function for									-
6		service								-
7	Engineer										OFF
8	RESERVED										OFF
			Emulation mode selection
			SW – 1		SW – 2				MODE
				OFF		OFF			Epson
				OFF		ON			Citizen
				ON		OFF			Star
				Dip Switch 2 Setting
SW	FUNCTION			ON					OFF		DEFAULT
1	Data Receive Error			Print ”?”				Ignore			OFF
2	Hexadecimal dump			YES					NO		OFF
3	Hand Shaking			XON/OFF				DTR/DSR			OFF
4	Word length			7 bits				8 bits			OFF
5	Parity check			Enable				Disable			OFF
6	Parity selection			EVEN					ODD		OFF
7	Baud Rate selection			Refer to the following table							OFF
8											OFF
				Baud rate selection
		Transmission speed					SW – 7			SW – 8
		1200 baud						ON		ON
		2400 baud						OFF		ON
		4800 baud						ON		OFF
		9600 baud						OFF		OFF

NOTE : When the word length is 7 bits, you can not parity check OFF status.

14