Samsung SRP-270 Series specifications Introduction

Page 2

Warning - U.S.

This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates uses, and can radiate radio frequency energy and if not installed and used according to the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Notice - Canada

This Apparatus complies with class Alimits for radio interference as specified in the Canadian department of communications radio interference regulations.

Get appareil est conforme aux normes class Adinterference radio tel que specifier par ministre canadien des communications dans les reglements dinterference radio.

Caution

Some semiconductor devices are easily damaged by static electricity. You should turn the printer OFF, before you connect or disconnect cables. This will help protect the printer against static electricity. If the printer is damaged by the static electricity, you should turn the printer OFF, and refer to your local service provider.

INTRODUCTION

The SRP-270 Roll Printers are designed for use with electronic instruments such as system ECR, POS, banking equipment, computer peripheral equipment, etc.

The main features of the printer are as follows:

1.High speed printing : 4.6 lines per seconds.

2.2 color dot-matrix printer.

3.RS-232C(SRP-270), RS-485 serial interface (SRP-270S), Parallel interface (SRP-270P),USB interface(SRP-270U).

4.The data buffer allows the unit to receive print data even during printing.

5.Peripheral units drive circuit enables control of external devices such as cash drawer.

Please be sure to read the instruction in this manual carefully before using your new SRP-270 series.

NOTE : The power-outlet should be near the equipment and it should be easy accessible.

2

Image 2
Contents Series Introduction Table of Contents Unpacking Checking the Contents of the printer boxInstalling the printer Functions Connecting the cables Connecting the AC adapter to the printerConnecting Interface Cable and Drawer Cable to the printer Installing the roll paper Ribbon Cassette InstallationRoll Paper Installation Page Page Page Setting the DIP switches Dip Switch 2 Setting DIP Switch 1 SettingEmulation mode selection Baud rate selectionParallel/USB Interface Specification Hexadecimal Dumping Character Test Completed Self testSelf-test printing Please press the Feed button Code Table 0 PC437 USA, Standard Europe International Character Set USA2 PC850 Multilingual 3 PC860 Portuguese 4 PC 863 Canadian French 5 PC 865 Nordic 19 PC 858 Euro International Character Control Commands List Epson modeCitizen mode CanStar mode Control code Hexadecimal Function Code Connectors Appendix aSerial InterfaceRS-485 Serial InterfaceRS-232CSerial Communication InterfaceExample GND Drawer Connector USB Interface Pin No Signal Name Assignment Function ColorSpecification Appendix BAppendix C Removing Jammed Paper