Samsung SRP-270 Series Connecting the cables, Connecting the AC adapter to the printer

Page 6

Chapter 2. Connecting the cables

2-1. Connecting the AC adapter to the printer

1). Make sure that the printer is turned off.

2). CHECK the label on the AC adapter to make sure the voltage required by the AC adapter matches that of your electrical outlet.

3). Plug the DC cord connector into the printer’s power connector.

4). Plug the AC adapter power cord into the wall outlet.

6

Image 6

Contents Series Introduction Table of Contents Checking the Contents of the printer box Installing the printerUnpacking Functions Connecting the cables Connecting the AC adapter to the printerConnecting Interface Cable and Drawer Cable to the printer Installing the roll paper Ribbon Cassette InstallationRoll Paper Installation Page Page Page Setting the DIP switches Dip Switch 2 Setting DIP Switch 1 SettingEmulation mode selection Baud rate selectionParallel/USB Interface Specification Hexadecimal Dumping Self test Self-test printing Please press the Feed buttonCharacter Test Completed Code Table 0 PC437 USA, Standard Europe International Character Set USA2 PC850 Multilingual 3 PC860 Portuguese 4 PC 863 Canadian French 5 PC 865 Nordic 19 PC 858 Euro International Character Control Commands List Epson modeCitizen mode CanStar mode Control code Hexadecimal Function Code Connectors Appendix aSerial InterfaceRS-232C Serial Communication InterfaceExampleSerial InterfaceRS-485 GND Drawer Connector USB Interface Pin No Signal Name Assignment Function ColorSpecification Appendix BAppendix C Removing Jammed Paper