Samsung 800TFT Back panel connectors, 13W3 signal cable connector, Kensington security slots

Page 6
Figure 2. Back panel connectors
Power adapter connector Connect the power adapter jack here.
15-pin, mini D-sub signal cable connector Connect a computer system to this connector.

Your Flat Panel Monitor

1

 

4

 

5

2

 

3

5

6

Figure 2. Back panel connectors

1

2

3

13W3 signal cable connector

Connect a 13W3 cable (Optional) from the video connector on your workstation to this

 

connector.

4

Power adapter cable holder slot

The plastic cable holder fits into this slot to protect the power adapter jack from being

 

inadvertently dislodged. To disconnect the power adapter, turn the plastic holder 1/4

 

turn to the left or right and pull the holder out of the cabinet.

5

Kensington security slots

This FPD offers you the opportunity to attach a Kensington-type security device in two

 

different locations; on the panel cabinet or on the tower stand. Please note that the

 

location on the panel cabinet is more secure than the one on the tower stand.

 

Kensington lock not included. Refer to your locking device documentation for

 

installation instructions.

6

USB hub receptacle

You may install a self-powered USB hub in this slot. Remove the cover to reveal the

available space.

4

Image 6
Contents SyncMaster 800TFT TFT-LCD MonitorOwner’s Instructions Unpacking your Monitor DO NOT REMOVE COVER OR BACK NO USER-SERVICEABLE PARTS INSIDEREFER SERVICING TO QUALIFIED SERVICE PERSONNEL RISK OF ELECTRIC SHOCK DO NOT OPENContents Portu- Italiano Español Deutsch Français EnglishPut your FPD in a location with low humidity and a minimum of dust Figure 1. Front panel Your Flat Panel MonitorItaliano Portuguese Deutsch Español Français English 4 OSM adjustment controls and direct-access controlsconnector Figure 2. Back panel connectors13W3 signal cable connector Power adapter cable holder slotTurn off your system and unplug its power cord InstallationFigure 3. Connecting your monitor to a PC cord for your locale to the AC inlet on the power adapterGetting Help Auto AdjustmentMaintenance of Your Flat Panel Display Plug and PlayTurn on the monitor Self-Test Feature Check STFCTurn off both your computer and the monitor Figure 4. FPD self-test screenfeature control. See the section on Direct-Access Buttons Adjusting Your FPDPower button and indicator screenAuto Adjustment Direct-Access FeaturesAuto Adjustment Español Français EnglishContrast OSM Lock/UnlockContrast or “+”Portuguese Deutsch Español Français English Coarse 1688 Auto AdjustmentAccessing the Menu System ItalianoFine and Coarse adjustments Table 1. Menu Adjustmentsclosely adjust your FPD to your preference the interference. If satisfactory results are notto their original factory settings Adjusting Your FPDTable 1. Menu Adjustments Continued button. The default time is 10 secondssee more detail new settingsoftware you are using nizePowerSaver Table 2. Power-saving modesTroubleshooting Table 3. Troubleshooting problemsTable 3. Troubleshooting problems Continued The power indicator blinks amberSpecifications Referring to Standard signal modes, pageAppendix Table 4. SpecificationsTable 6. 13W3 Connector Pin AssignmentsTable 7. Preset timing modes Display ModesPortuguese Deutsch Español Turn off your monitor and unplug its power cordFrançais English Changing the StandIndex FCC Information Regulatory InformationPortuguese Italiano Español Deutsch Français English IC Compliance NoticeU.S.A
Related manuals
Manual 26 pages 44.16 Kb Manual 24 pages 15.22 Kb