Panasonic DMR-E85H manual Flexible Recording, Recording from an external equipment

Page 16

Recording television programmes

Refer to the control reference on page 14.

Flexible Recording

[HDD] [RAM] [DVD-R]

The unit sets the best possible picture quality that fits the recording within the remaining disc space.

e.g.,

Recording from an external equipment

[HDD] [RAM] [DVD-R]

Preparation

≥Connect a video cassette recorder, etc. to this unit’s input terminals.

≥When recording bilingual programmes [HDD] [RAM]

Recording

Recorded

Remain

 

 

45 minutes in SP mode

60 minutes

Programme to be recorded

Preparation

Select the channel to record.

Perfectly fit!

Recording rate

between SP and LP

When both M 1 and M 2 is selected on the connected equipment, you can select the audio type in playback.

[DVD-R]

Select either M 1 or M 2 on the connected equipment. (You cannot select the audio type in playback.)

≥When the output signal from the external equipment is NTSC, change the “TV System” to “NTSC” in the SETUP menu

(➡page 41).

≥To reduce noise in input from external equipment, set “AV-in NR” to “On” in the SETUP menu (➡page 37).

≥Press [HDD] or [DVD] to select the recording drive.

e.g., Connecting other video equipment to the AV3 input

terminals

 

 

This unit

OPEN/CLOSE

REC

 

TIME SLIP

HDD DVD

 

 

TIME SLIPCH

1While stopped

Press [FUNCTIONS].

2Press [3, 4, 2, 1] to select

“FLEXIBLE REC” and press [ENTER].

FLEXIBLE REC

Recording in FR mode

Maximum rec. time

3 Hour 00 Min.

 

Set rec. time

 

3 Hour 00 Min.

 

 

 

 

 

 

Start

 

 

Cancel

 

SELECT

 

 

 

 

 

RETURN

 

3Press [2, 1] to select “Hour” and “Min.” and press [3, 4] to set the

recording time.

≥You cannot record more than 8 hours.

≥You can also set the recording time with the numbered buttons.

4When you want to start recording

Press [3, 4, 2, 1] to select “Start” and press [ENTER].

≥Recording starts.

≥The recording mode becomes FR mode.

To exit the screen without recording

Press [RETURN].

To stop recording partway

Press [∫].

To show the remaining time

Press [STATUS].

Remaining

DVD-RAM

REC 59

 

 

time

ARD

 

 

 

 

L R

 

 

 

RQT7462

S-VIDEO IN

VIDEO IN L/MONO - AUDIO IN - R

Yellow White Red

S-Video cable§

Audio/Video cable

Other video equipment

If the audio output of the other equipment is monaural, connect to L/ MONO.

§The S-VIDEO terminal achieves a more vivid picture than the VIDEO terminal.

1While stopped

Press [INPUT SELECT] to select the input channel for the equipment you have connected.

e.g., If you have connected to AV3 input terminals, select “A3”.

2Press [REC MODE] to select the

recording mode (XP, SP, LP or EP).

≥Using Flexible Recording (➡left), you can save content of a video cassette to 1 disc with the best possible quality of recording without wasting disc space.

3When recording from other video equipment

Start play on the other equipment.

4Press [¥ REC].

Recording starts.

To skip unwanted parts

Press [;] to pause recording. (Press again to restart recording.)

To stop recording

Press [∫].

Almost all videos and DVD software on sale have been treated to prevent illegal copying. Any software that has been so treated cannot be recorded using this unit.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Performance and safety, please read these Before connecting, operating or adjusting thisExample Instructions carefullyGetting started This Unit is Intended for USE in Moderate ClimatesTable of contents Useful featuresAccessories Please check and identify the supplied accessoriesGetting Batteries UseRemote control Control reference guideMain unit Unit’s displayWhen the unit is not to be used for a long time Do not connect the unit through a video cassette recorderBefore moving the unit, ensure the disc tray is EmptyConnecting to a television with 21-pin Scart Terminal Connecting to a VCR with 21-pin Scart terminalComponent video output Video OUT terminalConnecting an amplifier or system component ConnectionAmplifier’s rear panel Optical digital audio cableAuto-Setup Press 3, 4 to change the settingPress Enter when you have finished the settings Press 3, 4 to select the country and press EnterPress 3, 4, 2, 1 to select Setup and press Enter Selecting television type and aspectPress Functions To enjoy progressive videoWhen the following indicator appears on the unit’s display Point the remote control at the televisionTo change the code on the remote control Television operationHDD and Disc information HDD and discs you can use for recording and playPlay-only discs 12 cm/8 cm Discs that cannot be played HDD Hard disk drive handling care GettingPress W X CH to select the channel Recording television programmesPress ¥ REC to start recording Recording modes and approximate recording times Playing while you are recordingPress 1 Play Press Time SlipPress REC Mode to select Recording mode XP, SP, LP or EP Flexible RecordingRecording from an external equipment Press 3, 4, 2, 1 to select Start and press EnterTimer recording Using G-CODEsystem to make timer recordingsPress F Timer Press G-CodeManually programming timer recordings Press 3, 4 to select New TimerPress PROG/CHECK Press 1 to move through the itemsTo exit the timer recording list To put the unit on timer recording standbyCheck, change or delete a programme To change a programmePlaying discs Press 1 PlayBack PlayingOperations during play Skipping the specifiedTime Time Slip Manual SkipEditing operations during play Changing audioPress Audio Press Erase Press 2, 1 to select Erase and press EnterUsing menus to play MP3 Using the tree screen to find a groupPress 3, 4, 2, 1 to select a group Press TOP MenuUsing on-screen menus and Status messages Disc menu-Setting the disc contentOn-screen menus Press DisplayStatus messages Press StatusPlay menu-Change the play sequence Picture menu-Change the picture qualityEditing titles/chapters Editing titles/chapters and playing chaptersPress Direct Navigator Press 3, 4, 2, 1 to select the title Press 3, 4, 2, 1 to select the chapterTitle operations Cancel Protection §Chapter operations Press 3 to cancel Creating, editing and playing play listsPress 3, 4, 2, 1 to select Play List and press Enter Creating play listsEditing and playing play lists/chapters Play list operationsMove ChapterEntering text Show Enter Name screenPress 3, 4, 2, 1 to select a Character and press EnterTransferring dubbing titles or play lists Transfer DubbingOne Touch Transfer dubbing Press DubbingPress Enter to confirm DubbingPress 3, 4 to select Start Dubbing and press Enter Transferring dubbing a finalized DVD-RTo edit the transferring dubbing list DubbingFunctions window Press 3, 4, 2, 1 to select an item and press EnterPress 3, 4, 2, 1 to select Disc Management and press Enter Press 3, 4 to select the operation and press EnterDisc Name Top MenuDisc Protection Format DiscChanging the unit’s settings Common proceduresSummary of settings FunctionsConvenient functions Tabs Menus Options Underlined items are the factory presetsPicture Audio Mode for XP Recording Play k1.3 & Audio during SearchDynamic Range Compression DVD-VDolby Digital only Bilingual Audio SelectionProgressive TV SystemAV1 Output AV2 InputTuning Press 3, 4 to select Manual and press EnterPress 3, 4, 2 To select aPress 3, 4 to select Auto-Setup Restart and press Enter To change the setting all at once PAL!#NTSCPress 2, 1 to select Yes and press Enter Press 2, 1 to select the country and press EnterClock settings To cancel the Child LockChild Lock Clock startsSpecifications ReferenceGlossary Frequently asked questions Set upPageCover RecordingOn the television Error messagesOn the unit’s display ≥Select On in Grey Background in the Setup menu Troubleshooting guide≥Set the clock Display Troubleshooting guide Even when is pressed DVD-R disc using the highSpeed mode When transferring dubbing Ratings passwordErase operation Maintenance Safety precautionsIndex
Related manuals
Manual 54 pages 58.34 Kb
Top Page Image Contents