Mitsubishi Electronics LT-46151, LT-40153 About Auto Input Sensing Auto Output Sensing, Hdmi USB

1. Basic Setup and Operation 13

Setting Up TV Inputs, continued

About Auto Input Sensing/

Auto Output Sensing

This TV’s Easy Connect™ Auto Sensing feature detects most connections automatically.

Auto Sensing for Most Devices

When you first connect a device, the TV will:

a.Detect the connected device and automatically switch to it.

b.Prompt you to identify the device type.

c.153 Series. Prompt you to perform NetCommand set-up for the device, if available.

d.Repeat these steps for any other newly detected devices.

Which Jacks Trigger Auto Sensing?

TV Jacks and	Auto Sensing	AutoNo Sensing
Auto Sensing
Y/VIDEO (detected as composite video)	
Y/VIDEO plus Pb (detected as	
component video)
HDMI	
USB	
Digital Audio OUTPUT (orange jack)	
AVR AUDIO OUTPUT (red jack)	
SUBWOOFER OUTPUT (black jack)	
Digital Audio INPUT (orange jack)	
ANT (Antenna)		
IR NetCommand Output/External Con-	
troller Input (153 series)

The TV may not detect an HDMI device when the device is powered off. Detection of the device will occur the next time it is powered on.

When You First Connect a Device

•Most Device Types. Select the device type from the on-screen list. The device type you select here will appear as a device icon in the Activity menu.

•A/V Receiver

-- The TV detects audio connections on the DIGITAL AUDIO OUTPUT jack and the right (red) AVR AUDIO OUTPUT jack.

-- For an HDMI A/V receiver, select AVR from the list of device types if the A/V receiver is not recognized automatically.

•HDMI CEC Devices Compatible with the TV’s HDMI Control Feature. Compatible CEC- enabled HDMI devices are often recognized auto- matically by the TV. HDMI Control may allow you to control some functions of a CEC-enabled device. See Appendix C, “HDMI Control of CEC Devices.”

New Device Found screen for a device with HDMI control enabled. Select On to enable the TV’s CEC

control of the device. In some cases, as in the example above,

you will also be prompted to select a device name.

Tips on Auto Sensing

•Choose a different name for each input.

•The antenna input (ANT) is never detected, although you can turn off the unused antenna input in the Inputs > Name menu.

•Change the device type displayed in the Activity menu in the Inputs > Name menu (page 47). You must switch to a different input before changing the device type.

•153 Series. Any “learned” NetCommand IR codes will be erased if you change the device type in the

Inputs > Name menu.

Reactivating Auto Sensing for an HDMI Input

When you disconnect an HDMI device, Auto Sensing is disabled until you perform these steps.

1.Switch to any input other than the one to be dis- connected.

2.Disconnect the HDMI device.

3.Delete the removed HDMI device in the Inputs > Name menu (see “Removing an HDMI Device,” page 76).

4.Connect the new HDMI device and the New Device Found screen will display.