Mitsubishi Electronics LT-52151, LT-40153 Auto Setup, Microphone Placement, Initial Preparation

Page 35

3. Using TV Features

35

Sound Projector, continued

Auto Setup

153 Series

Auto setup uses a calibration microphone to optimize Sound Projector performance for most room condi- tions. If the room is very large or has many obstacles affecting the sound beams, you may wish to try manual setup, which is done without the microphone.

Initial Preparation

1.

Position and connect the TV as described under

 

“Before You Begin,” page 33.

2.

Power on the TV and external subwoofer, if any.

3.

Plug the microphone cable into the TV’s INPUT 3

 

left audio jack.

Microphone Placement

Make sure there are no large obstacles between the TV and microphone.

Place the microphone

-- On a tripod or on the backrest of your seating.

-- On a flat, level surface at least six feet away from the front of the TV.

-- At the same height yours ears would be when watching TV. The height must be within 3 vertical feet of the height of the TV’s speaker array.

-- Centered in front of the TV, not off to the side.

4. Place the microphone as described in the guide-

lines on this page.

Start Auto Setup

1. Press MENU and go to Initial > SoundPro.

TV

6 ft. minimum

Microphone

Set the microphone on a level surface at ear height at least six feet from the TV. Use a seat backrest or tripod so as to pick up sound from all directions.

Maximum height above speakers

2.

Press ENTER. Set Mode to Auto.

3.

Highlight START and press

 

ENTER.

5.Quietly exit the room right away. The calibration sequence will start in a few seconds and may be loud. It is important to leave the room as your pres- ence will interfere with the calibration process.

6.Wait for completion of setup before returning to the room.

7.Play some sample audio material to check the sound quality.

Note: Do not perform manual adjustments after run- ning Auto setup, as doing so will erase all set- tings defined during Auto setup.

8.Store the microphone out of direct sunlight and away from heat.

Height of TV speakers

Be sure the 3 ft. height of the

microphone is within three feet of the speaker height.

Microphone

Center the micro- phone in front of the TV.

Image 35
Contents LT-40153, LT-46153, LT-52153 LT-40151, LT-46151, LT-52151For Your Records FCC Declaration of ConformityContents Outdoor Antenna Grounding Replacement PartsIf Your TV Gets Damaged Installation NotesImportant Information About Your TV TV SoftwareSpecial Features of Your TV Remote Control Batteries Package ContentsWall-Mounting Stand InstallationWelcome screen First-Time Power-OnHome Fast Power On Retail Before You BeginTV Controls Remote ControlIR Sensor Power IndicatorSystem Reset TV Control PanelMemorizing Channels with Channel Scan For the ANT input Setting Up TV InputsSetting Up Other Inputs Channel Scan for Digital ChannelsInputs Name menu About Auto Input Sensing Auto Output SensingHdmi USB Watching DVDs or Videos CancelBasic TV Operation Watching Broadcast TVOther Information Making Picture AdjustmentsAudio Settings Other TV FeaturesPicture Quality Cable ManagementAuto Input/Auto Output Sensing Connection TypesInputs and Outputs Connector PanelsPb Pr Component Video IR-NetCommand Output/External Controller InputANT Antenna Hdmi Inputs High-Definition Multimedia InterfaceSuitable for use with Sound Projector surround sound Pb Pr Component Video DeviceHdmi Device Hdtv Cable Box, Satellite Receiver, DVD/ Blu-ray PlayerCable Box, Satellite Receiver, DVD Player Antenna or Cable TV ServiceDVI Video Device Composite Video DeviceAntenna or Wall Outlet Cable VCR or DVD Recorder to anDVD player ReceiverReceiver with Hdmi Output Audio-Only Device SubwooferSleep Sleep TimerSelecting an Input Redirecting Audio Output Controlling A/V Receiver VolumeChannelView Channel Listings Standard-Definition Digital Channels Status DisplayAbout Channel Numbers Standard-Definition Analog ChannelsTV Display Format Definitions TV Signals and Display FormatsSignal Definitions DVD Image DefinitionsDigital DVI Connecting a Computer to the TVThis TV accepts digital computer signals only Computer Video Connection Audio Video OutputComputer Display Formats Using the TV with a Personal ComputerComputer Video Adjustments Image ResolutionDisplaying the Menu Camera Images and Music FilesUSB Media Player Menu Playing a Slide Show or PlaylistSlideshow + Music --Slideshow Music only Thumbnail and Playlist Menus USB Media Setup MenuPicture Files Compatible with the USB Port Press ACTIVITY, select Watch Movie Cam, and press Enter Photos and Moving Video As Composite VideoBefore You Begin Basic SetupSound Projector Sound Projector TechnologyCustom menu Adjusting Beam AnglesAdjusting Levels Adjusting an External SubwooferInitial Preparation Auto SetupMicrophone Placement Start Auto Setup Press Menu and go to Initial SoundProIntroduction to Home-Theater Control Source device connected directly to the TVMenu Navigation Main MenuADV AdjustFrom the Adjust Picture menu From the Adjust Audio menu Language Audio Listen To StereoMono SAPAdvanced Picture Global ResetFilm Mode Auto, Off Enter twicePerfectTint Sliders Using PerfectColorUsing PerfecTint 153 Series Picture+ PerfectColor PerfectColor SlidersCaptions on Digital Channels CaptionsCaptions on Analog Channels DST InitialAnt Cable Adding/Deleting Channels Using the Channel Edit MenuEnergy Energy Usage Standard Fast Power Channel Ant AirStart AVR InputsDVD DVD2 DVR How is the Activity Menu Generated?Inputs Activity menu Photos MusicLock TV-PG ParentalTV-Y TV-GPanel Lock by TimeLock Time Unlock TimeImportant Note on NetCommand About NetCommand IR ControlIf You are Unable to Locate a Device’s IR Sensor IR Emitter PlacementPower key If the device has no Power OFF key, skip this step Initial NetCommand SetupAdding or Removing Device Keys from NetCommand Control Special Operation Methods Operating NetCommand-Controlled DevicesSpecial Operation Description and Setup How to Use Controlling Most Device TypesSP/EP More Key Menu and NetCommandNetCommand Specialized Device Keys With Any Connection Type Switching Audio to and from the A/V ReceiverControlling A/V Receiver Power Controlling Other A/V Receiver FunctionsBefore You Begin Setting Up A/V Receiver ControlPower and Volume Setup to Control A/V Receiver Power and VolumeUse this setup for Automatic Switching Audio or Audio/VideoDVD Input key Before You Begin Case 3 Automatic Audio Video Switching via HdmiMore About Using an Hdmi Connection Open the Inputs Learn menu NetCommand and press EnterAppendices Bypassing the Parental Lock Mitsubishi Unisen LCD HdtvThis page intentionally left blank Control modes Appendix B Programming the Remote ControlFunctions Available for Other A/V Devices More MenusCABLE/SAT VCR DVD Audio Programming the Remote ControlAudio Lock Universal A/V Receiver Control DVDCable Boxes Programming CodesAudio Amplifiers VCRs Satellite ReceiversAppendices71 DVD and Blu-ray Players SVAAppendices73 Device does not have CEC compatibility Action Appendix C Hdmi Control of CEC DevicesEnabling Hdmi Control of CEC Devices New Device Found screenDevice Found screen will appear Hdmi Control of an Hdmi A/V Receiver and Connected DevicesResolving CEC Conflicts Using Hdmi ControlAppendix D TV Care Cleaning RecommendationsCare of the Remote Control Service Appendix E TroubleshootingTV Reset Comparison Guide Service and Customer SupportTions Initial Channel Edit menuIf the New Device Read the ON-SCREENGeneral TV Operation Symptom Remarks TV Power On/Off Symptom Remarks TV Channels Symptom RemarksSound Symptom Remarks Picture Symptom RemarksReceiver with Hdmi Control Receiver Set Up for Audio and Video Switching overAppendix E Troubleshooting Trademark and License Information Mitsubishi TV Software GNU General Public License No Warranty This Limited Warranty does not Cover To Obtain Warranty ServiceWarranty Index Index Page System Reset MDEAservice@mdea.com
Related manuals
Manual 96 pages 27.73 Kb