5. NetCommand IR Control (265 Series) | 63 |
NetCommand Setup, continued
Adding or Removing Device Keys from NetCommand Control
After performing initial setup, you can add or remove individual keys under NetCommand control.
1.Switch the TV to the device. Press INPUT, highlight the device’s icon, and press ENTER.
2.Open the Inputs menu and highlight the Learn icon.
3.When the Learn screen displays:
•To add keys: Continue as described earlier under “Initial NetCommand Setup” on the opposite page.
•To delete keys: Highlight the name of the key you wish to delete and press CANCEL on the TV‘s remote control. Clears the check mark.
Operating NetCommand-Controlled Devices
Controlling Most Device Types
As an example of NetCommand control, if you are watching your cable box and you wish to tune to the next channel higher, press CHANNEL Up. NetCommand then sends the “learned”
1.Perform NetCommand setup for the device as described in this chapter.
2.When you wish to use the device, press INPUT.
3.Highlight the icon for the device.
4.Press ENTER to switch the TV to the device.
Note: if you have set up automatic input switching for the A/V receiver, the A/V receiver will automati- cally switch to the correct input for the device.
5.To operate the device using the TV’s remote control, press the TV key to put the remote control into TV mode.
6.Point the remote control at the TV (not the device) and press the key for the desired function.
7.Press the TOOLS key to access additional key func- tions you may have “learned” for the device.
Downloaded From
For assistance call 1(800)