6. NetCommand Control of an A/V Receiver (265 Series) | 71 |
Setting Up A/V Receiver Control, continued
NetCommand Control of a Device Con- nected to an HDMI A/V Receiver
Use this setup to have NetCommand control a device sending audio and video through the A/V receiver to the TV via HDMI.
You must have already completed the procedure under “Setup to Control Automatic Audio and Video Switch- ing via HDMI” on the opposite page. That procedure placed an icon in the Input Selection menu for the device (input) connected to the A/V receiver.
Any Connection | HDMI | ||
Type |
| Cable | |
Source | A/V | TV | |
Device | Receiver | ||
| |||
1.Set up NetCommand control of A/V receiver audio/ video switching via HDMI as described on the opposite page.
2.Press EXIT to close any open menus and return to normal TV viewing.
3.Press INPUT.
4.Highlight the icon for the A/V receiver input you wish to control.
5.Press ENTER to switch the TV to the A/V receiver and the A/V receiver to the input.
6.Open the Inputs > Learn menu.
7.Perform NetCommand “learning” for the con- nected )device by following the steps in “Initial NetCommand Setup,” page 62.
Downloaded From
For assistance call 1(800)