JVC XV-SA72SL manual Only for Dolby Digital DVD Video Discs

Page 60
OFF
OFF
OFF
OFF
MODE1
DVD1
DIGITAL AUDIO OUTPUT DOWN MIX COMPRESSION
DTS BASS MANAGEMENT AUTO STANDBY SCREEN SAVER
AV COMPULINK MODE
PRESS KEY
STREAM/PCM
PREFERENCE1 PREFERENCE2 SPK. SETTING

Initial settings

DOWN MIX

To playback a DVD VIDEO

disc recorded with surround multichannel audio correctly, the DOWN MIX setting must be properly made according to

your audio system.

Note that this setting affects

only the output signal from the ANALOG AUDIO output jacks when playing back a DVD VIDEO disc recorded with surround multichannel audio.

Lt/Rt

Should be selected when you enjoy multichannel surround audio by connecting the unit’s ANALOG AUDIO output to a surround decoder.

L0/R0

NOTES

The “COMPRESSION” function works only when playing back a disc recorded with DOLBY DIGITAL. The setting is not effective for other discs.

The “COMPRESSION” function does not work when the 3D PHONIC function is activated.

DTS BASS MANAGEMENT

 

 

This item controls the

 

 

 

output signals when playing

PREFERENCE1

PREFERENCE2 SPK. SETTING

DIGITAL AUDIO OUTPUT

STREAM/PCM

back DTS-encoded DVD

DOWN MIX

 

OFF

VIDEO discs.

COMPRESSION

OFF

DTS BASS MANAGEMENT

OFF

 

AUTO STANDBY

OFF

 

SCREEN SAVER

MODE1

 

AV COMPULINK MODE

DVD1

 

PRESS

KEY

 

OFF

Should be selected when you enjoy conventional 2-channel stereo audio by connecting the unit’s AUDIO output to a stereo amplifier/receiver or television set, or when you duplicate audio of a DVD VIDEO disc recorded with surround audio to your MD, cassette, etc.

OFF

When you enjoy multichannel surround audio by connecting the unit's 5.1-channel audio outputs to an amplifier equipped with 5.1-channel inputs.

NOTES

The “DOWN MIX” function does not work when the 3D PHONIC function is activated.

Some DVD AUDIO discs prohibit the 2-channel down- mix. For such a disc, you cannot get the down-mixed signal even if you set “DOWN MIX” to “Lt/Rt” or “Lo/ Ro”.

COMPRESSION

(only for Dolby Digital DVD VIDEO Discs)

This is the normal setting for DTS-encoded discs. Signals with the full frequency range are output from all speakers when playing back a DTS-encoded disc. This mode ignores all “Small” settings in the speaker setting screen (All “Small” settings are regarded as “Large”).

ON

All speaker settings (front, center and rear) in the speaker setting screen are effective when playing back DTS-encoded discs. The low frequency signal fed from the sub-woofer output is boosted up regardless of the “Bass redirect setting” in the speaker setting screen.

See page 59 for the speaker setting screen.

AUTO STANDBY

 

 

 

 

When the unit is stopped for

 

 

 

SPK. SETTING

more than 30 minutes or 60

PREFERENCE1

PREFERENCE2

DIGITAL AUDIO OUTPUT

STREAM/PCM

minutes, the unit enters standby

DOWN MIX

 

 

OFF

COMPRESSION

 

OFF

mode automatically.

DTS BASS MANAGEMENT

 

OFF

AUTO STANDBY

 

OFF

 

 

SCREEN SAVER

 

MODE1

 

 

AV COMPULINK MODE

 

DVD1

 

 

PRESS

KEY

 

 

60

 

 

 

 

Initial settings

When enjoying a DVD VIDEO disc recorded with the Dolby Digital format at low or middle volume, setting COMPRESSION to ON makes you hear sound comfortably.

ON

PREFERENCE1

PREFERENCE2

SPK. SETTING

DIGITAL AUDIO OUTPUT

STREAM/PCM

DOWN MIX

 

 

OFF

COMPRESSION

 

OFF

DTS BASS MANAGEMENT

 

OFF

AUTO STANDBY

 

OFF

SCREEN SAVER

 

MODE1

AV COMPULINK MODE

 

DVD1

PRESS

KEY

 

 

 

Time is set to 60 minutes.

30

 

Time is set to 30 minutes.

OFF

 

The auto standby function is off.

Audio is played back with the dynamic range compressed.

OFF

Audio is played back as it was recorded.

58

Image 60
Contents 96$%.96$6 Important for Laser Products Table of Contents Features IntroductionSupplied accessories AV compulink cable xTo select a scene angle from the angle list display Angle Press and hold Angle for more than 1 second÷ During DVD Video playback Safety precautions Important cautionsPreliminary knowledge Names of parts and controlsFront panel OPEN/CLOSE buttonPROGRAM/RANDOM indicators Multi-information window Display windowRear panel Remote control unit @ Infrared signal-emitting window TV/VIDEO Cancel button 23Button Previous button 27, 32Operational Principles On-screen displaysBasic operations of on-screen displays Opening displayParental Lock display see DVD Control for DVD Video displayDVD Control for DVD Audio display To prevent the monitor from burning out Screen Saver CD Control displayVCD Control display for Video CD/ Svcd MP3 Control display seeHow to use numeric buttons On-screen guide iconsAbout discs Playable disc typesAudio formats Playable discsDisc structure Getting started ConnectionsBefore making any connections To connect to a conventional TVTo connect to a TV with the component video input jacks Blue Component video cable Green Red Unit Not suppliedRed White Audio cable Supplied Blue Green About Scan Mode To connect to an audio amplifier or receiverRed White Audio cable Supplied Amplifier or receiver Audio/Video CableSupplied Amplifier or receiver To connect to audio equipment with a digital input Using the remote control unit To connect the power cordTo install batteries in the remote control unit Precautions for the safe use of batteries PrecautionRemote sensor Remote sensorTo use the remote control unit for TV operation Setting the remote control signal for operating your TVYou can operate your TV from the remote control unit Manufacturer code list+10 Basic operations Turning on/off the unitInserting and removing discs Press 0 OPEN/CLOSE to close the disc trayBasic playback To start playbackTo stop playback completely To stop playback temporarilyMethod 1 from the remote control unit only To advance or reverse playback rapidly while monitoringTo locate the beginning of the scene or song MethodResuming playback To memorize the interrupted positionTo resume playback Unit memorizes the interrupted positionAdvanced operations FunctionAudio Video Playing from a specific position on a discTo locate a desired scene from the DVD menu Press TOP Menu or MenuUse the numeric buttons to select the desired item ¶ Whenever a DVD disc is loadedUnit status Disc type What is Specified Use the numeric buttons to specify the numberTo locate a desired selection using 4 or ¢ Press on ScreenPress Enter Message area For DVD AudioUse Cursor 5/∞ to move to Time SEARCH, then press Enter Use the numeric buttons 0 to 9 to enter the timeScreen example Selected time Message area For Audio CDWhen you make a mistake To locate a desired scene from the display DigestPress Digest Use Cursor 5/∞/2/3 to move to select the desired sceneSpecial picture playback To playback in slow-motion SlowTo display continuous still pictures Strobe Press and hold 8 for more than 1 secondUse Cursor 5/∞/2/3 to move the zoomed position Press Zoom + orTo return to normal playback Press Enter ¶ During playback or while pausedChanging the playback order To playback in the desired order ProgramUse Cursor 5/∞ to move to Program and press Enter Press 3 to start program playTo playback in random order Random Use Cursor 5/∞ to move to RandomTo quit program playback To quit random playback in the middleRepeat playback Press RepeatUse Cursor 5/∞ to move to REPEAT, then press Enter During DVD Video playbackSelected repeat mode For Svcd Audio CD/Video CD/SVCDDisc type Display window On-screen display To stop repeat playback PressSelecting a scene angle To select a scene angle from the normal screen AngleFrom normal screen Use Angle or Cursor 2/3 to select the desired angleFrom on-screen display Use Cursor 2/3 or Angle to select the desired angle numberTotal number Recorded anglesChanging the language and sound To select the subtitle language SubtitleFrom on-screen display except DVD Audio To change the audio language or sound Audio Press Audio S.FREQUse Audio S.FREQ or Cursor 2/3 to select the desired audio Use Cursor 5/∞ or Audio S.FREQ to move to AudioTo adjust the picture character VFP Press VFP Progressive Scan to select Desired presetMiscellaneous functions Adjust the level of the parameter using Cursor 2/3 Select the desired mode by using 3D PhonicSelected effect mode To simulate surround sound 3D PhonicPress Cursor 2/3 to adjust the effect level Use Cursor 5/∞ to move to Time SelectDuring playback for DVD AUDIO/Audio CD While stoppedTo select a still picture on a DVD Audio disc From normal displayUse Cursor 5/∞ or page to move to Use Cursor 2/3 or page to select the desiredTo playback a bonus group of a DVD Audio disc Press Cursor 5 or ∞ while holding downDisplay Window TV screen Checking the sampling frequency Press Audio S.FREQ for more than one secondActual sampling frequency Display window What is MP3? MP3 disc playbackAbout MP3 disc OperationsHighlight a desired Track using Cursor Specifying the desired Group and TrackSelected Group SelectedTrack Track timeRepeat playback You can repeat playback of the current track or group¶ During playback or while stopped To stop repeat playbackInitial settings How to set preferencesSelecting preferences Language and display preferenceSetting changes as follows Which show what isUnit can display on Screen guide icons or Characters on the picture43 LB. Letter Box Conversion 43 PS. Pan Scan ConversionAuto Wide Television screen Normal Wide Television screenAudio and system preference Only for Dolby Digital DVD Video Discs Speaker setting Speaker Channel settingSpeaker size settings Available only when selecting Expert Select the speaker to be set using CursorBass redirect Available only when selecting Expert Speaker level Available only when selecting ExpertDelay Available only when selecting Expert Test tone Available only while setting Level or Limiting playback by childrenTo set Parental Lock for the first time To change the settings Enter your 4-digit password using the numeric buttons 0 toPress Enter while holding down 7 on the remote control unit Moves to the Password field When selecting noUse the Cursor 5/∞ to move to YES, then press Enter Press 0 OPEN/CLOSEAV Compu Link remote control system Connection and setupAdditional information To AV Compu Link II or EX DVD playerTurn on the main power of the television OperationYou connect the component video output to your TV How to handle discs Maintenance of discsCare and handling of discs Label sideTroubleshooting Symptom Possible case RemedySpecifications Appendix a Table of languages and their abbreviations Appendix B Country code list for Parental Lock JVC 0801AOMDTEJSC