Additional information
PICTURE
Symptom | Possible cause | Remedy |
|
|
|
No picture is displayed on the monitor. | Connection of video cable is incorrect. | Connect the cable correctly. |
|
|
|
| Input selection of TV is incorrect. | Select correctly. |
|
|
|
| Disc is not playable. | Use a playable disc. (See page 4.) |
|
|
|
No picture is displayed on the monitor or | The unit is in the progressive scan mode | Set the Scan mode selector on the rear |
the screen is blurred or divided into two | (i.e. the PROGRESSIVE indicator is lit) | panel to "480i", or set it to "REMOTE" and |
parts. | though it is connected to a TV via the | make the Progressive scan mode inactive |
| VIDEO or | by using the |
|
| button (see pages 7 and 8). |
|
|
|
A picture is noisy or blurred. | The unit is connected to a VCR directly and | Connect the unit so that the picture signal |
| the copyguard function is activated. | flows directly to the TV. |
|
|
|
| With some discs, a picture may be blurred | Set "PROGRESSIVE MODE" to "VIDEO". |
| when setting "PROGRESSIVE MODE" to | (See page 49.) |
| "FILM" or "AUTO". |
|
|
|
|
A picture does not fit the television screen. | MONITOR TYPE is not correctly set. | Select monitor type correctly. (See page 49.) |
|
|
|
| Television is not correctly set. | Set the television correctly. |
|
|
|
The upper and lower parts of the | It depends on the setting on the TV. | Adjust the TV screen using the control on |
preference display are cut off when using |
| the TV. |
|
| |
|
|
|
AUDIO |
|
|
|
|
|
Symptom | Possible cause | Remedy |
|
|
|
No audio is reproduced. | Connection is incorrect. | Check the connection. |
|
|
|
| Input selection of amplifier is incorrect. | Select correctly. |
|
|
|
No audio is reproduced when playing back | The audio signal is not derived from the | Use AUDIO OUT when playing back such |
a DVD disc recorded with | unit's DIGITAL OUT. (See page 50.) | discs. |
(88.2 kHz or more) linear PCM audio using |
|
|
the DIGITAL OUT jack. |
|
|
|
|
|
Audio volume is low when playing back the | The audio level recorded on a DVD VIDEO | Turn up the volume of the TV or amplifier/ |
unit, compared with the TV or VCR. | is lower, compared with TV broadcasting. | receiver. |
|
| Note that you should turn down the volume |
|
| before switching back to TV broadcasting, |
|
| to prevent outputting the sudden big |
|
| sound. |
|
|
|
Sound is distorted or noise is generated. | Disc is dirty. | Wipe the disc surface. (See page 5.) |
|
|
|
Additional | information |
|
|
60