JVC XV-S500BK manual Appendix B Glossary, Dts

Page 66

Additional information

Additional

information

 

 

Appendix B: Glossary

480i/480p

Indicates the number of scan lines and scanning format of an image signal. 480i indicates 480 scanning lines with interlace format, and 480p indicates 480 scanning lines with progressive format.

Aspect ratio

A ratio which defines the shape of the rectangular picture in a TV. It is the width of the picture relative to the height. The conventional TV picture is 4:3 in aspect ratio.

Bitstream

The digital form of multichannel audio data (e.g., 5.1- channel) before it is decoded into its various channels.

Channel, CH

Stereo or multichannel audio consists of "channel" signals. "Stereo" audio consists of left and right channels, while 5.1-channel Dolby Digital consists of six channels (front left, front right, rear left, rear right, center and LFE (Low-Frequency Effect channel for sub- woofer, etc.).

Chapter

The smallest division on DVD VIDEO. It is a division of a title and similar to a track for Audio CD or Video CD.

Component video

Video signals with three channels of separate information that makes up the picture. There are some types of component video, such as R/G/B and Y/ CB(PB)/CR(PR).

Composite video

A single video signal commonly used in most consumer video products that contains all luminance, color, and synchronization information.

Dolby Digital (AC3)

A six-channel system consisting of left, center, right, left rear, right rear and LFE (Low-Frequency Effect channel for sub-woofer, etc.) channels. All processing is done in the digital domain.

Not all Dolby Digital discs contain six (5.1) channel information.

Dolby Surround/Dolby Prologic

Dolby Surround is a five-channel system consisting of left, center, right and left rear, right rear channels. All processing is done in the digital domain.

Dolby Prologic is a four-channel system consisting of left, center, right and rear channel (the single rear channel is usually played through two speakers).

Downmix

Internal stereo mix of multichannel surround audio by a DVD player. The downmix signals are output from stereo output connectors.

DTS

A Digital Surround audio encoding format configured with six (5.1) channels, similar to Dolby Digital. It requires a decoder, either in the player or in an external receiver. DTS stands for Digital Theater Systems.

Not all DTS discs contain six (5.1) channel information.

Dynamic range

The difference between the loudest and softest sounds.

Dynamic range compression

The dynamic range compression (DRC) reduces the dynamic range so that you can turn down the volume to avoid disturbing others yet still hear the detail of quiet passages.

Extension

Several letters at the end of a filename. Filename extensions usually follow a period and indicate the type of information stored in the file.

Finalize

When conducting multisession recording, this means the closing of a session (fixing) by indicating the halting of writing so as to prevent the addition of any more sessions.

Fs

See "Sampling frequency".

ID3 tag

The tag embedded in an MP3 file indicating what song, artists, and album it comes from. You can edit these tags.

Interlace scan

In the conventional video system, a picture is shown on the display monitor in two halves. The Interlace scan system places lines of the second half of the picture in-between lines of the first half of the picture.

ISO 9660 Format

The most common international standard for the logical format for files and directories on a CD-ROM.

JPEG

A popular file format for still image compression. JPEG stands for Joint Photographic Experts Group. There are three sub-types of the JPEG format as

follows.

 

• baseline JPEG:

used for digital cameras, web,

 

etc.

• progressive JPEG: used for web

• lossless JPEG:

an old type and rarely used

 

now

64

Image 66 Contents
XV-S500BK/XV-S502SL LET0200-002B J/UJMises en garde, précautions et indications diverses Table of Contents Supplied accessories R6PSUM-3/AA15F battery x AC power cord xIntroduction Safety precautions Important cautionsNon-playable discs About discsPlayable disc types Audio formatsDisc structure Video CDs and SVCDs with Playback Control functionBefore making any connections Getting startedConnections To connect to a TVAbout Scan Mode Connection to a TV equipped with component jacksTo connect to a stereo audio amplifier/receiver Setting Source type of DVD VideoProgressive Mode Film Source Video SourceTo connect the power cord To connect to digital audio devicePrecautions for the safe use of batteries Using the remote control unitTo install batteries in the remote control unit PrecautionSetting the remote control signal for operating your TV To use the remote control unit for TV operationTo control the volume of a JVCs amplifier or receiver Manufacturer code listBasic operations Before operationTurning on/off the unit Use 5/∞ to select a desired language Initial setup before using the unitUse 5/∞ to select a desired digital output signal type Press EnterOPEN/CLOSE Basic playbackInserting and removing discs 0OPEN/CLOSETo stop playback temporarily To start playbackTo stop playback completely PressResuming playback When the resume mode is set to Disc ResumeWhen the resume mode is set to on To memorize the interrupted positionTo resume playback ¶ While stopped, or no disc is insertedTo advance a still picture frame-by-frame Variable speed playbackTo advance or reverse playback rapidly while monitoring To playback in slow-motionTo locate the beginning of the scene or song To locate a desired selection using 4 or ¢To locate a desired selection using the numeric buttons Press 4 or ¢Press on Screen Other convenient functionsTo check the playback status On Screen AngleExample of the menu bar for DVD Video To change the brightness of the display windowPress 5 or ∞ while holding down Angle See page 35 for details about the menu barPress TOP Menu or Menu Advanced operationsTo locate a desired scene from the DVD menu Press 3 or TOP MenuPress on Screen twice To specify a desired titleUse the numeric buttons to select the desired item Use 2/3 to move to , then pressTo locate a desired scene from the display Digest Use the numeric buttons 0 to 10 to enter the desired timePress Digest To playback in the desired order Program playback Disc type Unit status What is displayedChanging the playback order Use 5/∞/2/3 to move To select Desired scenePress 3 to start program playback To playback in random orderRandom playback Use 2/3 to move to RNDTo stop and quit random playback Repeat playbackPress Repeat To stop repeat playback PressAudio CD/Video CD/SVCD Use 5/∞ to select A-BDuring DVD Video playback To quit A-B repeat playbackPress Subtitle Changing the language, sound and scene angleTo select the subtitle language Subtitle For DVD VideoUse Audio or 5/∞ to select the desired audio To change the audio language or sound AudioPress Audio AudioTo select a scene angle of DVD Video Angle From the angle listFrom Angle selection window Special picture playback and picture/sound effect To display continuous still pictures StrobeTo zoom in/out pictures Zoom Adjust the level of the parameter using 5/∞ To adjust the picture character VFPUse 2/ 3 to select the desired preset Press VFP Progressive ScanTo simulate surround sound 3D Phonic Select the desired mode by using 2/3Press 5/∞ to adjust the effect level Press 3D PhonicUse 2/3 to select icon you want to work with Menu bar functionsTo bring up the menu bar Press on Screen againSelected Icon Operation Use To select the repeat mode amongMenu bar functions for DVD Video Press Enter to open the pull-down windowMenu bar functions for Audio CD/Video CD/SVCD Press Enter to activate random playback Audio channelsOperations MP3 disc playbackAbout MP3 disc Basic operationsMove the bar to a desired Group using 5/∞ ¶ When the MP3 Control display is shownSelecting the desired Group and Track Use the numeric buttons to specify a desired Track number Direct selectionUse the numeric buttons to specify a desired Group number MP3 ControlWhat is JPEG? Jpeg disc playbackAbout Jpeg disc Basic operations To see a desired pictureTo playback another picture ¶ During Jpeg picture is shown on the TV screen To zoom in/out the picture ZoomPlayback pictures from the beginning of the disc ¶ After inserting a Jpeg discSelect a desired file using 4/¢ Press Selecting the start point of the slide showFrom the Jpeg Control display Jpeg TV Screen Selected repeat modeRepeat function DisplayChanging the initial settings Selecting preferencesAbout the Preference display Menu item Setting options LanguageTable of languages and their abbreviations Monitor Type Progressive Mode VideoPicture FilmDigital output signal chart AudioAnalog Down MIX Dolby Surround StereoRange Compression Auto Others Press Enter Parental Lock display Limiting playback by childrenUse 5/∞ to select the country code ¶ While the Others page of the preference display is shownMoves to Password To change the settingsEnter your 4-digit password using the numeric buttons 0 to Available You can change the Parental Lock settings laterAssociated pull-down menu while points the appropriate item Use 5/∞ to select a desired option and pressEnter Enter Front panel Additional informationNames of parts and controls Display windowRemote control unit 10 0 +10AV Compu Link remote control system Connection and setupOperation Symptom Possible cause Remedy TroubleshootingPower Operation Picture Frequently Asked Questions Question Answer Ref.Specifications Appendix a Country code list for Parental Lock Appendix B Glossary DTSMP3 MpegPBC Appendix C Index Authorized Service Centers Limited Warranty JVC 0102KTYDTEJSC