JVC LET0227-003A Connecting to optional audio equipment, Connecting to a digital audio device

Preparations

Connecting to optional audio equipment

Connecting to a stereo audio amplifier/ receiver

Connect the unit’s AUDIO OUT (LEFT/RIGHT) jacks to any line-level inputs (such as AUX, DVD, CD, etc.) of an audio amplifier or receiver.

AUDIO (DVD) IN

RIGHT LEFTAmplifier or receiver

Red	White
	Audio cable (not supplied)

White Red

The unit

This illustration is upside down. (The bottom side is up.) For details on the connectors’ name, see page 38.

NOTE

Sound recorded on DTS-encoded DVD VIDEO or DTS- encoded Audio CD discs are not output from the analog (AUDIO OUT LEFT/RIGHT) jacks of the unit.

Connecting to a digital audio device

You can enjoy sound of enhanced quality by connecting the unit’s DIGITAL OUT (either OPTICAL or COAXIAL) jack to a digital input of an amplifier, etc., using an optical or coaxial digital cable. The digital audio signal on a disc will be transferred directly from the unit. If the connected digital audio equipment is a Dolby Digital or DTS decoder or an amplifier with a built-in decoder, you can enjoy high-quality surround sound.

NOTES

•Connect the unit and the digital audio device by using either an optical digital cable or a coaxial digital cable.

•It is not recommended to use the digital jacks for dubbing. When recording the sounds (DVD VIDEO, SVCD, Video CD or Audio CD) played back on the unit, record them through the analog jacks.

•Depending on the disc, no signal may be output from the DIGITAL OUT. Make an analog connection in this case.

•Set [DIGITAL AUDIO OUTPUT] in the [AUDIO] preference display correctly according to the connected digital audio equipment. If setting made for [DIGITAL AUDIO OUTPUT] is incorrect, loud noise may be generated causing damage to the speakers (see page 34).

AUDIO

DigitalRIGHT LEFT

equipment

Coaxial	Audio cable
digital cable
(not supplied)	(not supplied)
Optical
digital
cable
(not
supplied)

The unit

When using the DIGITAL OUT (OPTICAL) jack, remove the protection cap. Do not lose the removed cap.

When the DIGITAL OUT (OPTICAL) jack is not used, replace the protection cap in the jack.

This illustration is upside down. (The bottom side is up.) For details on the connectors’ name, see page 38.

Preparations

5