JVC LET0227-003A manual To use the remote control unit for TV operation, Press Enter

AMP VOL

Preparations

TV - DVD

TV STANDBY/ON switch

Numeric buttons

TV/VIDEO

CANCEL

ENTER

AMP VOL

To use the remote control unit for TV operation

You can operate your TV from the remote control unit.

To set the remote control signal for operating your TV

1 Set the TV - DVD switch to “TV.”

2 Hold down TV/VIDEO - CANCEL until step 4 is finished.

3 Enter the manufacturer code of your TV listed below by using the numeric buttons (0 to 9).

Example for a JVC TV:

To enter the manufacturer code “01”: Press “0” then “1.”

Hint

When the unit is shipped, the manufacturer code is set to “JVC” (01).

4 Press ENTER.

Manufacturer code list

Manufacturer	No.	Manufacturer	No.
AIWA	36	MIVAR	29
BEIJING	22	NEC	20
CCE	02	NOBLEX	22
CHANGHONG	34	NOKIA	31
DAEWOO	17, 37	PANASONIC	04, 11
FERGUSON	27	PEONY	34, 38,
			39
FINLUX	30	PHILCO	10, 17,
			21
FUNAI	32	PHILIPS	02
GRADIENTE	15, 20	RCA	05
GRUNDIG	19	SAMSUNG	12, 33,
			34, 35
HITACHI	10
ITT	28	SANYO	13, 16
JINXING	38	SEARS	13

Manufacturer	No.	Manufacturer	No.
JVC	01, 23,	SHARP	06
	24, 25
		SONY	07
KONKA	40	TCL	41
LG	18	THOMSON	26
(GOLDSTAR)
MAGNAVOX	02	TOSHIBA	08,14
MITSUBISHI	03	ZENITH	09

5 Release TV/VIDEO - CANCEL.

6 Try to operate the TV by pressing TV STANDBY/ON .

If your TV turns on or off, you have successfully set the control signal.

The following buttons can be used for operating the TV.

To use 5/∞(CH+, CH–), 2/3(VOL–, VOL+), TV/ VIDEO - CANCEL and numeric buttons for TV control, set the TV - DVD switch to “TV.”

TV DVD

	TV		Turns the TV on or off.
TV/VIDEO			Switches the TV input mode
CANCEL			between TV and VIDEO.
TV1	~	TV-/--	Selects the TV channels directly.
1		10	* For some TVs, pressing “+10”
	TV0
	0		functions as the “100+,” while
			“10” functions as the ENTER
			button if your TV requires pressing
			the ENTER button after selecting a
			channel number.
MUTING			Mutes the TV sound.
	+10
+			Changes the TV channels.
CH
CH
-
VOL-		VOL+	Adjusts the TV volume.

NOTE

If there is more than one code listed for the manufacturer of your TV, try them one by one until you succeed.

To control the volume of a JVC’s amplifier or receiver

You can control the volume of a JVC’s amplifier or receiver by using the AMP VOL +/– buttons on the remote control unit.

Pressing the AMP VOL + button raises the audio volume of the amplifier or receiver, while pressing the AMP VOL– button lowers the volume.

Preparations

9