Input Menu, Formats, Profiles, Picture Menu

Input Menu
INPUT	PICTURE	DISPLAY	PATTERNS
FORMATS
INPUTS			DVI
ASPECT			ANAMORPHIC
PROFILE
RECALL			F 1 2 3 4
STORE			1 2 3 4

Formats

1.Input Select: OSD Video-S-Video- RGB-YCrCb-DVI

●The Pass-Thru input cannot be selected from the OSD since an OSD is not available on that input. Use the Input button on the remote to select it. The DVI Input will not display an OSD unless there is a source con- nected to it.

2.Aspect Ratio 4:3-Letterbox-Anamorphic

●This selection should match the aspect ratio of the source, not the display. The aspect ratio of the display should be selected in the Setup menu.

Profiles

1.Profile: Factory-1-2-3-4-5-6-7-8

2.Store: 1-2-3-4-5-6-7-8

To store a Profile (in the Input Menu):

1.Press Menu button on the remote

2.Make all required adjustments.

3.Use the Function Up/down keys to select Profile

4.Use the Value Left/Right keys to select Profile

5.Press Enter

To recall a Profile (in the Input menu):

1.Press Menu button on the remote

2.Use the Function Up/Down keys to select Recall

3.Use the Value Left/Right keys to select profile 1-8

4.Press Store

5.There are separate banks of eight Profiles for NTSC and PAL

●When using a 4:3 source on a Wide Angle screen there are black bars on the left and right of the image. The sidebars can be changed to gray using the Blanking Level control located in the Display menu. If filling the entire screen is desired, select Letterbox. The image will fill the screen but the top and bottom 1/3 of the image will be cut off (overscanned).

When watching 2:35 aspect ratio movies on a 16:9 (1:77) screen, it is normal to see black bars at the top and bottom of the image.

●The screen shape used in the installation must be set in the Setup Menu during installation for proper Aspect Ratio mapping. Anamorphic Aspect Ratio with 4:3 screens and the Wide-4:3 settings are not available on units with scan rates, 540p, 600p and Frame Doubling. See Setup section for details.

Note

Do not leave the 4:3 image with a Wide Angle screen on for long periods of time on a projector or plasma display. This can cause permanent image burn-in. Image burn-in is not covered by warranty

Picture Menu

Use these commands to fine-tune the image.

●After tuning the image, if the power is turned off without storing the profile, the factory default value will be re- stored.

INPUT	PICTURE	DISPLAY	PATTERNS
BRIGHTNESS		50
CONTRAST		50
COLOR		50
TINT		50
DETAIL		4
ADVANCED COLOR SYS			NORMAL

Brightness

Factory 50

Adjust the brightness of the picture image.

Contrast

Factory 50

Adjusts the contrast of the picture image.

Input Menu

FORMATS

Formats

Profiles

Picture Menu

Brightness

Contrast