RS232
Patterns Menu
The best approach to system setup is to use a DVD that offers the proper test patterns. This way, the system is aligned for the entire signal path. If a test DVD is not avail- able, then use the internal test patterns provided in this unit.
●The test pattern generator in this unit is set to SMPTE stan- dards. To insure proper output levels for display setup, the picture controls in this unit cannot be accessed when the test patterns are being used. Adjust levels, if needed, in the display device.
INPUT | PICTURE | DISPLAY | PATTERNS |
TEST PATTERNS |
| ON | |
SELECT |
| CONVERGENCE | |
AVAILABLE PATTERNS
Gray Step | : Check gray scale |
Cb Ramp | : Check linearity of Cb channel |
Cr Ramp | : Check linearity of Cr channel |
Y Ramp | : Check linearity of Y channel |
Black | : Full Black screen |
Green Screen | : Check for defective pixels |
Red Screen | : Check for defective pixels |
Blue Screen | : Check for defective pixels |
Convergence | : Check convergence of display |
Border | : Use for H&V positioning |
Multiburst | : To check bandwidth |
Window | : Check displays power supply |
PLUGE | : Set Brightness and Contrast |
Color Bars | : Color bars for decoder check |
Rev Bars | : Color bars for decoder check |
RS232 INSTRUCTIONS
Connector | : |
Baud rate | : 19,200 default, 8 bit,1 stop bit and |
| No Parity |
Pin Configuration | : Pin 5=Ground |
| Pin 3=RX in |
| Pin 2=TX out |
All commands are sent using ASCII text strings.
●A command must start with the string header
13