Osd (continued)
Color
Factory 50
Display Menu
Adjust the color density of the picture image.
Tint
Factory 50
Tint is not available with YPrPb or PAL sources
Detail
Factory 4
● The Detail circuit is a powerful tool for image quality. The |
settings have been optimized for the output scan rate and |
resolution. However, the viewer’s tastes plus the types of |
software and display require making adjustments of this |
setting to |
to increase detail in poor quality video material. It is rec- |
ommended that adjustments be made in small increments |
until the desired results are achieved and then store these |
custom settings in the Profiles. It is important to not use |
INPUT | PICTURE |
|
|
POSITION
HORIZONTAL
VERTICAL
BORDER LVL
LEFT
BOTTOM
DISPLAY | PATTERNS |
|
|
25
25
0
RIGHT
TOP
too much Detail since the image will start to look artificial. |
Typically, digital displays will need less detail than analog |
displays. High quality software will need less detail than |
poor quality ones. Reducing the Detail level can help to |
reduce the visibility of MPEG artifacts on some DVDs and |
satellite systems and noise with VHS tapes. The best re- |
sults are achieved by adjusting the levels to the software |
being viewed instead of just using test patterns. |
Advanced Color System
Normal (Default) / Bypass
For some DVDs with computer animation or with very high levels of color, the chroma edge processing circuits may not be needed and can be turned off (Bypass). For most sources, the Normal setting should be selected. These settings can be stored as a Profile.
●Any changes to the picture level adjustments are automati- cally stored after one minute has passed without making any changes. This information is stored separately for each input. As each input is selected the last used settings will automatically be recalled. If picture levels are adjusted but then the input is changed before one minute has passed, the changes for that input will not be stored and the previ- ous settings will be recalled the next time that input is used.
Use these commands to adjust the image position and edge blanking. It is recommended to adjust sizing, position and blanking in the display device first with this unit in the Factory preset setting. Then use this unit’s controls only if the display runs out of range or does not offer these controls. This should be done by a qualified technician.
Horizontal Position
Not functional on this unit.
Vertical Position
Not functional on this unit.
Border LVL (Blanking level)
Setting Values: 0-100
This adjusts the blanking from black to white. This can be used to create a gray side bar for use with 4:3 aspect ratio sources on wideangle screens to help reduce the chance of image
Left
Adjusts the left edge border (blanking).
Right
Adjusts the right edge border (blanking).
Bottom
This adjusts the bottom edge border (blanking).
Top
Adjusts the top edge border (blanking).
●This unit will store unique blanking settings for each as- pect ratio which are automatically stored and recalled when the different aspect ratios are selected
12