Basic operations
Basic operations
STANDBY/ON indicator |
NOTE |
Make sure that the TV - DVD switch on the
TV 
DVD remote control unit is set to “DVD” when using the 5/∞/2/3 and numeric buttons
for controlling the player.
About invalid operation icon
When you press a button, and if the player does not accept its operation, 
appears on your TV screen. Operations are occasionally unacceptable even if 
is not displayed.
Note that some operations may not be accepted. For example, some discs may not allow rapid advance/reverse or slow- motion playback.
•CANNOT READ THIS DISC (The player cannot play back the disc.)
•OPEN (The disc tray is opening.)
•CLOSE (The disc tray is closing.)
•NO DISC (No disc is loaded.)
NOTES
•Even if you turn off the player, the player is not disconnected from the AC power source as long as it is connected to the wall outlet. This state is called standby mode. In this state, the player consumes a very small amount of power.
•You can change the picture of the opening display. (See page 26.)
Initial setup
When you turn on the player for the first time, the following message appears on the TV screen.
EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO SETTING
YES - PRESS ENTER NO - PRESS CANCEL
1 Press ENTER.
The first page of the DVD PLAYER SET UP display appears. The
ON SCREEN LANGUAGE options
2 Press 5/∞ to select the desired language.
You can select the
SPANISH.
Turning on/off the player
Press DVD 
STANDBY/ON on the remote control unit or press 
on the front panel.
The STANDBY/ON indicator on the front panel, which lights in red during standby, lights in green.
The left and right sides of the display window are illuminated.
The opening display appears on the TV screen, and the following messages may appear at the bottom of the opening display.
NOW READING
NOW READING
Message area
•NOW READING (The player is reading the disc information.)
•REGION CODE ERROR! (The region code of the DVD VIDEO disc does not match the player. The disc cannot be played back.)
3 Press ENTER.
The second page is shown, in which the
MONITOR TYPE options
4 Press 5/∞ to select the desired monitor type.
For a normal (conventional) TV, select [4:3 LB] or [4:3 PS]. For a
10