Additional information
Troubleshooting
Power
Power does not come on.
\Power plug is not inserted securely. Plug in securely.
Audio
DVD VIDEO disc playback sound level is lower than TV broadcast sound level.
\Set the [D.RANGE CONTROL] preference to [TV MODE] (see page 30).
Analog audio output is distorted.
\Set the [OUTPUT LEVEL] preference to [LOW] (see page 30).
Operation
“REGION CODE ERROR!” is shown on the TV screen.
\Region code of the inserted disc does not match the player. Check the region code of the disc printed on the disc jacket.
Operation is not possible.
\Microcomputer malfunction due to lightning or static electricity. Turn off the power and unplug the power cord, then connect the power cord again.
\Moisture condensation caused by a sudden change of temperature or humidity. Turn off the power, then turn it on a few hours later.
\The disc does not allow the operation, or an unplayable disc is inserted. Check and replace the disc (see page 2).
[TRAY LOCK] is displayed on the display window and the disc tray does not open.
\When you press 0 while pressing down 7 on the player in standby mode, the tray lock function is activated. The disc tray cannot be opened or closed in this status. To release this status, press 0 while pressing down 7 on the player in standby mode. ([LOCK OFF] is displayed on the display window.)
MP3/WMA/JPEG/MPEG-4/DivX
No sound and/or no picture comes out.
\
\Check the files you want to play back.
Files (tracks) are not played in the recorded order.
\This player plays the files in the alphabetic order. So, the playback order can vary.
WMA files cannot be played back.
\The file is copy protected.
\The file is recorded with a bit rate under 48 kbps. The player does not support such WMA files.
\The format of the file is not asf.
DivX files are played back without sound.
\This player can play back the MP3 sound for the audio part of the DivX files. Select the proper audio CODEC when making DivX files.
Additional information
Picture
Picture is noisy.
\The player is connected to a VCR directly and the copyguard function is activated. Connect the player so that the picture signal flows directly to the TV.
\With some discs, the picture may be blurred when [PICTURE SOURCE] is set to [FILM] or [AUTO]. Set [PICTURE SOURCE] to [VIDEO(NORMAL)] or [VIDEO(ACTIVE)].
Picture is distorted when using COMPONENT VIDEO OUT or
\Both the component connection and
No picture is displayed on the TV screen, or the picture is devided in two parts.
\The Progressive scanning mode is activated. Change the scanning mode to the Interlaced scanning mode by doing one of the following:
-When the VIDEO SIGNAL SELECTOR is set to “480p,” set the VIDEO SIGNAL SELECTOR to “480i.”
-When the VIDEO SIGNAL SELECTOR is set to “REMOTE,” press and hold down VFP - PROGRESSIVE SCAN for a few seconds.
34