Installation
CAUTION
•Do not rest your arm on the monitor or lean against the monitor.
•Do not hold the LCD panel when installing the monitor.
•Make sure to install the monitor securely to prevent the monitor from falling over, which causes damage to the monitor or injury.
7Using the monitor on the stand
You can place the monitor in the following two ways when using the monitor on the supplied stand.
4
To detach the stand
CAUTION
• Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel being damaged.
You can tilt the monitor from about 6° upward to about 6° downward.
•When the monitor is not tilted (0°), the guidelines align as illustrated below.
About 6°
0°
About 6°
Guidelines
The illustration of the monitor is of
CAUTION
•Be careful not to pinch your fingers in the gap between the monitor and the stand.
•When the stand plate is attached to the lower position of the stand body (☞ “To adjust the stand height” on page 5), you cannot tilt the monitor downward.
When the stand plate is attached to the higher position of the stand body (☞ “To adjust the stand height” on page 5), you can lift the stand up by about 148° and place the monitor as illustrated below.
•Remove the screws on the left and right sides of the stand (see the illustration below), then lift the stand up by about 148°.
Make sure of attaching the removed screws after lifting up the stand.
•To place the monitor as illustrated on the left again, remove the screws on the left and right sides of the stand, return the monitor angle to 0°, then attach the removed screws.
Screw (silver) | About 148° |
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The illustrations of the monitor are of
CAUTION
•When lifting up the stand, lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel being damaged.
•Be careful not to pinch your fingers in the moving parts.
•Make sure to lift the stand up until it stops (about 148°); otherwise the monitor may fall over.
•Place the monitor on a mat to avoid scratching the table surface.
•Do not place the monitor in this way when the stand plate is attached to the lower position of the stand body (☞ “To adjust the stand height” on page 5).
| Attachment screws |
Screw holes for | Stand |
stand attachment |
|
Monitor
The illustration of the monitor is of
When installing the stand to the monitor, insert the guides of the stand into the guide holes on the monitor to place the stand on the correct position. Then fix the stand firmly with the attachment screws.
Guide holes
Guides
Monitor
Screw holes for stand attachment (on the monitor)
Screw holes for |
|
stand attachment | Stand |
(on the stand) |
|