Kramer Electronics Using the FC-5, Transmitting Commands via a PC or Remote Controller

Page 17

6 Using the FC-5

You can use your FC-5to transmit commands via the:

•PC or remote controller, see Section 6.1

•Contact closure, see Section 6.2

•Relays, see Section 6.3

•Contact closure and relays, see Section 6.4

6.1Transmitting Commands via a PC or Remote Controller

You can use your FC-5to transmit commands via a PC or remote controller:

Figure 13: Transmitting Commands via a PC or Remote Controller

Connect a PC or Remote Controller to the COM1 port and a controlled unit is connected to the COM2 port. In this example, the PC or Remote Controller transmits user-defined commands to the Kramer switcher

14	FC-5 - Using the FC-5

Image 17

Contents FC-5 Page Figures Introduction Achieving the Best Performance Getting StartedOverview Your FC-5 Protocol Translator Feature FunctionFeature Installing and Running the Kramer FC-5 Manager Software Configuring the Kramer FC-5 Manager SoftwareTranslation List Window Using the Translation List WindowEntering Data in the New Command Window Editing Data in the Command Window Erasing a Command from the Command Translation List Window Connecting a PC Connecting a PC Config PortTo PC Setting the DIP-SwitchesAssigning the Translation List Driver Commands Transmitting Commands via a PC or Remote Controller Using the FC-5Transmitting Commands via the Contact closure Transmitting Commands via the Contact ClosureTransmitting Commands via the Relays Transmitting Commands via the RelaysTransmitting Commands via the Contact closure and Relays Transmitting Commands via the Contact Closure and RelaysDownloading from the Internet Connecting the PC to the RS-232 Config PortUpgrading the FC-5 Firmware JTG Sender Window Upgrading FirmwareRK-3T 19 rack adapter Technical SpecificationsOnly the first purchase customer may enforce this warranty Safety Warning