Kramer Electronics FC-5 user manual Transmitting Commands via the Relays

Page 19

6.3Transmitting Commands via the Relays

You can use your FC-5to transmit commands via the relays:

Figure 15: Transmitting Commands via the Relays

A PC or Remote Controller is connected to the COM1 port. Relay 1 is connected to the blinds, and relay 2 is connected to the lighting system. On each 3-pole terminal block connector, connect either: C to NO, or C to NC

Figure 16: Relay Pinout

C

NO

NC

Common

Normally Open (that is, the electricity is switched ON)

Normally Closed (that is, the electricity is switched OFF)

16

FC-5 - Using the FC-5

Image 19
Contents FC-5 Page Figures Introduction Achieving the Best Performance Getting StartedOverview Your FC-5 Protocol Translator Feature FunctionFeature Installing and Running the Kramer FC-5 Manager Software Configuring the Kramer FC-5 Manager SoftwareTranslation List Window Using the Translation List WindowEntering Data in the New Command Window Editing Data in the Command Window Erasing a Command from the Command Translation List Window Connecting a PC Connecting a PC Config PortTo PC Setting the DIP-SwitchesAssigning the Translation List Driver Commands Transmitting Commands via a PC or Remote Controller Using the FC-5Transmitting Commands via the Contact closure Transmitting Commands via the Contact ClosureTransmitting Commands via the Relays Transmitting Commands via the RelaysTransmitting Commands via the Contact closure and Relays Transmitting Commands via the Contact Closure and RelaysUpgrading the FC-5 Firmware Connecting the PC to the RS-232 Config PortDownloading from the Internet JTG Sender Window Upgrading FirmwareRK-3T 19 rack adapter Technical SpecificationsOnly the first purchase customer may enforce this warranty Safety Warning