Kramer Electronics FC-5 user manual Transmitting Commands via the Contact Closure

Page 18

6.2Transmitting Commands via the Contact Closure

You can use the FC-5to transmit commands via the contact closure (see also Section 6.4):

Figure 14: Transmitting Commands via the Contact closure

The INPUTS contact closure remote control pins let you temporarily route an input to the output by momentarily attaching an input to the GND (Ground) pin (do not connect more than one PIN to the Ground PIN at the same time). In this example INPUT 3 is routed to the output, by temporarily attaching PIN 3 to PIN GND, and a Kramer switcher is connected to the COM2 port

FC-5 - Using the FC-5

15

Image 18
Contents FC-5 Page Figures Introduction Getting Started Achieving the Best PerformanceOverview Feature Function Your FC-5 Protocol TranslatorFeature Configuring the Kramer FC-5 Manager Software Installing and Running the Kramer FC-5 Manager SoftwareUsing the Translation List Window Translation List WindowEntering Data in the New Command Window Editing Data in the Command Window Erasing a Command from the Command Translation List Window Connecting a PC Config Port Connecting a PCSetting the DIP-Switches To PCAssigning the Translation List Driver Commands Using the FC-5 Transmitting Commands via a PC or Remote ControllerTransmitting Commands via the Contact Closure Transmitting Commands via the Contact closureTransmitting Commands via the Relays Transmitting Commands via the RelaysTransmitting Commands via the Contact Closure and Relays Transmitting Commands via the Contact closure and RelaysConnecting the PC to the RS-232 Config Port Upgrading the FC-5 FirmwareDownloading from the Internet Upgrading Firmware JTG Sender WindowTechnical Specifications RK-3T 19 rack adapterOnly the first purchase customer may enforce this warranty Safety Warning