Kramer Electronics user manual Configuring the Kramer FC-5 Manager Software

Page 9

5Configuring the Kramer FC-5 Manager Software

This section describes how to:

Install and run the Kramer FC-5Manager software, see Section 5.1

Use the Translation List window, see Section 5.2

Connect and assign the driver commands to the translation list, see Sections 5.2.1, 5.2.2 and 5.2.3

5.1Installing and Running the Kramer FC-5 Manager Software

To install the FC-5Manager software:

1.Insert the CD-ROM in the CD-ROM drive; double click the FC-5Manager icon. The Port selection window appears:

Figure 3: Port Selection Window

2.Choose the appropriate COM port for configuration via the serial cable and click OK.

The Translation List window (see Figure 4) opens.

6

FC-5 - Configuring the Kramer FC-5 Manager Software

Image 9
Contents FC-5 Page Figures Introduction Achieving the Best Performance Getting StartedOverview Your FC-5 Protocol Translator Feature FunctionFeature Installing and Running the Kramer FC-5 Manager Software Configuring the Kramer FC-5 Manager SoftwareTranslation List Window Using the Translation List WindowEntering Data in the New Command Window Editing Data in the Command Window Erasing a Command from the Command Translation List Window Connecting a PC Connecting a PC Config PortTo PC Setting the DIP-SwitchesAssigning the Translation List Driver Commands Transmitting Commands via a PC or Remote Controller Using the FC-5Transmitting Commands via the Contact closure Transmitting Commands via the Contact ClosureTransmitting Commands via the Relays Transmitting Commands via the RelaysTransmitting Commands via the Contact closure and Relays Transmitting Commands via the Contact Closure and RelaysConnecting the PC to the RS-232 Config Port Upgrading the FC-5 FirmwareDownloading from the Internet JTG Sender Window Upgrading FirmwareRK-3T 19 rack adapter Technical SpecificationsOnly the first purchase customer may enforce this warranty Safety Warning