Kramer Electronics RC-81R user manual Mounting the Device Housing, Mounting the RC-8IR Faceplate

Page 10

Installing the RC-8IR Universal Room Controller

5.2Mounting the Device Housing

The device housing is mounted to the wall via the two housing mounting screws holes, as illustrated in Figure 6:

Figure 6: Mounting the Device Housing

5.3Mounting the RC-8IR Faceplate

1.Place the faceplate on the RC-8IRso that the two screw mounting holes are aligned (see Figure 7).

2.Insert the two mounting screws and tighten with a screwdriver.

Figure 7: Mounting the Faceplate

7

Image 10

Contents Model Contents FiguresTables Introduction Getting StartedOverview Up to five machines with unique IP addressesRC-8IR Front Panel Features Your Universal Room ControllerDefine the RC-8IRright side panel Installing the RC-8IR Universal Room Controller Installing the RC-8IR Universal Room ControllerSetting the Labels and Button Caps Button Cap OrientationMounting the Device Housing Mounting the RC-8IR FaceplateUsing the RC-8IR Universal Room Controller Example of a Typical RC-8IR ConfigurationExample of a Typical RC-8IR Setup in the Lecture Auditorium Commands Configuration Operating the RC-8IRAn Example of Operating the RC-8IR Shows an operating exampleLocking the Front Panel Using the Macro ButtonsUsing the Internal Web Turning the Light of the Backlit Buttons On and OffFlash Memory Upgrade Downloading from the InternetConnecting the PC to the RS-232 Port Upgrading FirmwareTechnical Specifications Installing the Web AppletLimited Warranty 2900-REV