Kramer Electronics RC-81R user manual Installing the RC-8IR Universal Room Controller

Installing the RC-8IR Universal Room Controller

Figure 3 and Table 3 define the RC-8IRrear panel:

Figure 3: RC-8IR Rear Panel

Table 3: RC-8IR and Rear Panel Features

#	Feature	Function
1	N.U Switch	Not used
2	PROGRAM Switch	Switch to OFF for normal operation;
		Switch to ON for firmware upgrade
3	RS-485 TERM. Switch	Switch to ON for RS-485 line termination
4	FACTORY DEFAULT Button	Press to return to the factory default settings, including all the
		configured buttons and the network settings1
5	Ethernet Port	Connects to a PC or other controller through computer networking
6	Grounding Screw	Connect to grounding wire

5Installing the RC-8IR Universal Room Controller

This section describes the installation of the RC-8IRand includes:

•Setting up the labels on the buttons, according to your specific requirements2

•Mounting the RC-8IRdevice to the wall

•Installing the button caps

•Mounting the faceplate

•Setting of the device

1 Including the factory default IP number: 192.168.1.39 (an IP number is a device's numerical address as expressed in the format specified in the Internet Protocol)

2 It is recommended to place labels before mounting the faceplate

5