Technical Specifications | Kramer Electronics RC-81R specs

Technical Specifications

7.4Installing the Web Applet

Follow these steps to install the Web Applet1:

1.Connect RC-8IRto your PC through computer networking.

2.Start the RC Configuration Software and connect to the RC device (see the RC Configuration and Installation Guide2).

3.In the Device menu select Upgrade Applet option and browse to MC.dat file included in the package.

4.Wait until uploading is completed and the success message appears. Click OK.

Table 6: Technical Specifications3 of the RC-8IR Universal Room Controller

PORTS:	2 RS-232 on terminal block connectors
	1 RS-485 on a terminal block connector
	1 ETHERNET RJ-45 port
OUTPUTS:	2 relays on terminal block connectors (36V AC or DC, 2A, 60VAC maximum on
	non-inductive load)
	2 IR emitters on terminal block connectors
POWER SOURCE:	12V DC, 155mA
DIMENSIONS:	11.4cm x 3.7cm x 6.9cm (4.49" x 1.45" x 2.72", W, D, H)
WEIGHT:	0.3kg (0.67lbs) approx
ACCESSORIES:	Kramer 3.5mm to IR Emitter Control Cable (C-A35/IRE-10), power supply, two
	extra M3x5 screws, Java based control software (internal), Windows®-based
	Kramer control software
OPTIONS:	Kramer 3.5mm to IR Emitter Control Cable (C-A35/IRE-10), 15 meter and 20 meter
	IR emitter extension cables

1 This section is applicable only to firmware version 26.0 and higher and requires RC Configuration Software version 1.26.0.38 and higher

2 On our Web site at http://www.kramerelectronics.com

3 Specifications are subject to change without notice