5.3Cutting an Opening in the Table
To cut an opening in the table:
1.Place the cut out template (that is included with your
2.Attach the template to the table with the included screws (if using the cut out template).
3.Following the inside edge of the template, cut a hole in the table surface with a sabre or keyhole saw according to the dimensions shown in Figure 4 (not to scale).
iThe thickness of the table should be 76.2mm / 3 inches or less.
123+2mm
225+2mm
Figure 4: Cut out Dimensions
4.Unscrew and remove the template from the surface of the table and clean the table surface.
Take care not to damage the table.
If needed, you can download a
!Kramer Electronics is not responsible for any damage caused to the table.
11 |