Kramer Electronics 2900-3000730 Rev 2 Connecting the Cables, Inserting Pass-through Cables

5.5Connecting the Cables

When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so on):

1.Insert the cables to their appropriate connectors from underneath.

2.Secure the cables to the tie holes using the included self-locking ties.

Do not secure the cables too tightly or too loosely. Leave a small amount of slack.

After the TBUS-6xlis connected to mains power and the proper cables, it is ready for use.

5.6Inserting Pass-through Cables

When replacing inserts with the pass-through insert, for example, to connect a laptop, do the following:

1.Remove the two screws attaching the split pass-through bracket.

2.Remove the split grommet.

3.Insert the cable through the rectangular opening.

4.Open the split grommet slightly and insert the required cables.

5.Place the split bracket around the grommet and position this assembly over the Inner Frame.

6.Place the two screws appropriately and tighten the split bracket together with the grommet and inserted cables to the inner frame.

7.Insert the self-locking ties through the tie holes to secure the cables to the inside walls of the enclosure.

TBUS-6xl - Installing the TBUS-6xl 13