Kramer Electronics 2900-3000730 Rev 2 Inserting the TBUS-6xl through the Cut Out Opening

Page 15

5.4Inserting the TBUS-6xl through the Cut Out Opening

To install TBUS-6xlin the opening:

1.Remove the protective rubber guard from around the outer rim of the TBUS-6xlhousing. Beware of the sharp edge!

2.Carefully insert the unit into the prepared opening (see Figure 5).

3.Take the support brackets under the table and place them into the support bracket grooves on both sides of the unit (see Figure 1).

4.Verify proper alignment of the unit before tightening the mounting screws.

5.Tighten both mounting butterfly screws upward until they reach the table surface (from underneath). Tighten firmly (see Figure 5).

6.Tighten the locking butterfly screws downward until tight against the mounting bracket.

Figure 5: Inserting TBUS-6xl into the Prepared Opening

12

TBUS-6xl - Installing the TBUS-6xl

Image 15
Contents Modular TBUS-6xl Page Figures Introduction Getting Started Achieving the Best PerformanceGlossary Overview An optional insert kit to replace one power socketYour TBUS-6xl Enclosure Feature FunctionTBUS-6xl Optional Inserts TBUS-6xl Optional Inner FramesPower Socket Power Specs Type Power Socket OptionsPower Cord Type Description Power Cord OptionsAssembling the Inner Frame Installing the TBUS-6xlMounting the Power Socket Assemblies Installing a MegaTOOL Installing the Inner Frame123+2mm 225+2mm Cutting an Opening in the TableInserting TBUS-6xl into the Prepared Opening Inserting the TBUS-6xl through the Cut Out OpeningInserting Pass-through Cables Connecting the CablesAdjusting the Height of the Inner frame TBUS-6xl Boardroom Installation Using the TBUS-6xlPower Source Technical Specifications of the Assembled TBUS-6xlTBUS-6xl Page Safety Warning