1.Manually turn on the device you want to control.
2.Find your device’s brand in the Brand Code list section of the accompanying code list. Circle the number for your brand and keep the list handy.
Code |
| |
Liste | descodes/ | |
| Códigos | |
Listade |
| |
3.Press and hold the device key you want to program (the POWER key illuminates). While you’re holding down the device key, use your other hand to press and hold the remote’s POWER key at the same time (the POWER key turns off).
4.Wait until the POWER key comes on and stays on. Then release both keys.
5. Look at the numbers you circled for your device’s brand code. Press those numbers on the remote keypad.
Note: For
6.Point the remote directly at
the front panel of the device you want to control. Press GUIDE on the remote and wait 2 seconds. The remote is sending a single code for your device’s brand.
Did your device turn off?
YES: Press the remote’s POWER key to turn your device back on. Then test all of the following remote keys that your device uses: VOL+, CH+, 0 digit, PLAY, and STOP. If these keys work, press OK/ENTER. If they don’t, repeat this step until your device turns off again.
NO: Press GUIDE again. The remote sends the next code for your brand.
Keep pressing GUIDE every 2 seconds until your device turns off. When it does, press OK/
ENTER.
4