Advanced Punch-Through

Volume punch-through as described above occurs automatically. Advanced punch-through lets you specify one device for all volume commands for each non-audio mode (SAT•CBL•STREAM, DVD, DVR•AUX1, or VCR•AUX2). You can specify either the TV or AUDIO device (or an AUX key operating a TV or audio device).

1.Press and hold the device key whose volume commands you want to send to the TV or audio device. The POWER key turns on.

2.While holding down the device key, press and hold the VOL + key. The POWER key turns off.

3.After holding down both keys for 3 seconds, the POWER key turns on and stays on. Release both keys.

4.Press the device key you want the Volume Punch-Through to be directed to from the selected mode (TV, AUDIO, or AUX key). The POWER key ﬂashes.

Note: The device key pressed in step 4 must be programmed with a TV or AUDIO component. If an invalid key is pressed, the POWER key ﬂashes four times, then turns off.

Important: Once you have programmed any device with a speciﬁed Volume Punch-Through, the Volume Punch-Through for all other devices defaults to AUDIO. If you do not want other components’ Volume Punch-Through to default to AUDIO, you must manually program them, using steps 1-4.

Resetting Volume Punch-Through

You can reset volume punch-through to its default behavior (sending volume commands to either TV or AUDIO, whichever was pressed last).

1.Press and hold the device key whose volume punch-through functionality you want to reset to the original behavior. The POWER key turns on.

2.While holding down the device key, press and hold the VOL – key. The POWER key turns off.

3.After holding down both keys for 3 seconds, the POWER key turns on and stays on. Release both keys. The POWER key ﬂashes, and the volume punch-through for this device is reset to the original behavior.

To reset volume punch-through for other devices, repeat the steps above for that device key.