1. Manually turn on the device you want to control.
2.Press and hold the device key you want to program (the POWER key illuminates). While you’re holding down the device key, use your other hand to press and hold the remote’s POWER key at the same time (the POWER key turns off).
3.Wait until the remote’s POWER key comes on and stays on. Then release both keys.
4.Point the remote directly at
the front panel of the device you want to control. Press SKIP FWD on the remote and wait 2 seconds. The remote is sending a single code for your device.
Did your device turn off?
YES: Press the remote’s POWER key to turn your device back on. Then test all of the following remote keys that your device uses: VOL+, CH+, 0 digit, PLAY, and STOP. If these keys work, press OK/ENTER. If they don’t, repeat this step until your device turns off again.
NO: Press SKIP FWD again. The remote sends the next code for your device.
Keep pressing SKIP FWD every 2 seconds until your device turns off. When it does, press OK/
ENTER.
TIP: Because there are so many codes, you may have to press the SKIP FWD key many times— possibly hundreds of times.
10