To reset the IP phone:
Note: Restarting of the telephone may take a few minutes.
1. Press the Mute button.
2. Using the dial pad, press the following keys in sequence: 73738#
o The display shows the message "Reset values? *=no #=yes".
3. If you want to reset the phone without resetting any as signed values, press * (asterisk).
o The display prompts "Restart phone? *=no #=yes".
If you want to reset the phone and any previously assigned (programmed) values, press # (the pound key).
Note: Use this option only if your phone has programmed, static values.
o The display shows the message "Resetting values" while your conference phone resets its programmed values,
such as the IP address, to its default values, and re-establishes the connection to the server.
o The display prompts "Restart phone? *=no #=yes".
4. If you want to restart the phone, press #.
5. If you want to terminate the restart and re store the phone to its previous state, press *.
Note: If the above reset procedure cannot be performed or does not solve the problem, and your System Administrator
approves, the phone may be power cycled.
To power cycle the phone:
1. Unplug the phone then plug it back in.
o The phone reconnects to the server and reinitializes everything.
Note: It may take a few minutes before the phone can be used again.
To retrieve a message:
1. See your system manager for instructions regarding your local message retrieval procedures.
Note: If the stutter dial tone (Audible Message Waiting) feature is not presently administered for your station, request
that your system manager do the necessary administration.
To prevent the other person on the line from hearing you:
1. Press the Mute button.
o The other party cannot hear you. The indicator next to the Mute button lights when Mute is active.
To reinstate two-way conversation:
1. Press the Mute button again.
o The other party can hear you again.
o The indicator next to the Mute button turns off.
To place or answer a call without lifting the handse t, or to use the Speakerphone with any feature:
1. Press the Speaker button.
o The indicator next to the Speaker button lights and the speaker handles voice control. The first available call
appearance line activates.
2. Place or answer the call.
or, Access the selected feature.
3. If needed, adjust the speaker volume by pressing the Volume Control ( ) button until you reach the
desired volume level.
o As you press the Volume Control button, the top display area shows the volume level.
4610SW IP Telephone End User Guide | 16 | Page