LG Electronics LST-4200A owner manual Analog Monitor Connections, Display Formats Overview

Connections (Continued)

Display Formats Overview

•The HDTV Tuner offers various display formats and multiple video outputs. If the HDTV Tuner is connected to A/V systems, the HDTV Tuner can provide video signal formats 1080i, 720p, 480p, and 480i.

•1080i, 720p, 480p, and 480i modes are available for component video (YPbPr) outputs.

•1080i, 720p, and 480p modes are available for RGB and DVI outputs.

•480i mode is available for VIDEO, S-VIDEO, and COMPONENT VIDEO outputs.

•The HDTV Tuner has two digital audio outputs; Dolby Digital 5.1 and PCM. The HDTV Tuner sends out a digital audio signal to OPTICAL and COAXIAL audio outputs if digital broadcasts are being received by the HDTV Tuner.

Analog Monitor Connections

INSTALLATION

Antenna

OR

Cable TV

Wall Jack Panel

TV Connection Panel

ANTENNA	AUDIO INPUT		VIDEO	S-VIDEO
INPUT			INPUT	INPUT
	L	R	L

OR

To AUDIO OUT

HDTV Receiver Connection Panel

1Connect the “Antenna/Cable” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.

ote

There might be some areas where the signal strength could be too high. If so, you may need to connect the antenna to an attenuator. Screw the attenuator onto the “ANT IN” jack. (Refer to page 10.)

2 Connect the “ANT LOOP OUT” jack from the HDTV Receiver to the “Antenna In” jack on your TV using a coaxi- al RF cable.

3jacks on your TV using RCA-type cables. If your TV is equipped with an S-Video jack, use the S-VIDEO OUT

jack.

(The Output Selection must be set to YPbPr, refer to Display Format Setup on page 17.)Connect the “AUDIO OUT” and “VIDEO OUT (MONITOR OUT)” jacks from the HDTV Receiver to the “A/V IN”

ote

On-Screen display and Menus are only seen on these connections if the display format settings are set to 480i and YPbPr. (Refer to page 17.)

11