LG Electronics LDX-514 owner manual Troubleshooting, Symptom Cause Correction

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.

Symptom	Cause	Correction
No power.	The power cord is disconnected.	Plug the power cord into the wall out-
		let securely.
Abnormal or no picture	The TV is not set to receive DVD+VCR	Insert a disc or tape. (Check that the
	signal output.	disc or tape indicator in the display
		window is lit.)
	The video cable is not connected	Select the appropriate video input
	securely.	mode on the TV so the picture from
		the DVD+VCR player appears on the
		TV screen.
	The HDMI mode is on.	Set HDMI on the front panel to OFF.
	Unit output setting and TV resolution	Check TV capability.
	capabilites mismatch.	Check mode of connections
		(eg. S-Video, Components etc.).
		Check unit Resolution setting accord-
		ing to TV capability and mode of con-
		nection.
	Wrong cable connection.	Check the connection.
Distorted or no sound.	The equipment connected with the	Select the correct input mode of the
	audio cable is not set to receive	audio receiver so you can listen to the
	DVD+VCR signal outpt.	sound from the DVD+VCR.
	The audio cables are not connected	Connect the audio cable into the jacks
	securely.	securely.
	The power of the equipment connected	Turn on the equipment connected with
	with the audio cable is turned off.	the audio cable.
	The AUDIO options are set to the wrong	Set the AUDIO options to the correct
	position.	position.
	In HDMI mode, audio selection is not	Change AUDIO setup to PCM mode.
	set to PCM.
The playback picture is	The disc is dirty.	Clean thd disc.
poor.
	The TV channels are not tuned in	Check tuning, carry out tuning again.
	properly.
	Tape heads are dirty.	Clean video heads.
	Tape is a rental or was recorded on	Use CH/TRK (+/-) for manual tracking
	another VCR.	adjustment while tape is playing.

40