Cloning Learning Setup
Learning the Master TV Setup
Instructions for the Clone Programmer to Learn the Master TV Setup
Use MPI Cable to Connect LT2002 Clone Programmer to Master TV MPI Port
If there is a good connection, “THE CLONE HAS CONTROL OF TV” message will appear. Press any key on the Installer remote.
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION | XX | |
THE TV IS VERSION | XX | |
THE SW IS REVISION | XX | |
CLONE CLOCK= | XX:XX | |
TV | CLOCK= | XX:XX |
Learn Setup from Master TV
Press 1 to select the “LEARN FROM TV” option, then press ON/OFF, POWER, or ENTER to go to the Memory Bank Selection Menu. Pick the Memory ”Bank” you want to store the master TV’s setup in by press- ing either Channel key repeatedly to choose Memory 1, 2 or 3. (If you choose a Memory “Bank” that has a master device’s setup pro- grammed into it, that setup will be overwritten by the new master TV’s setup.) Once the Clone memory bank is selected, press ON/OFF, POWER, or ENTER. The Clone memory bank you have selected will be shown. Press ON/OFF or POWER to begin copying the master TV’s setup.
Set the Clock (Optional)
Set the time on a Master TV’s Clock. (If the time has already been copied from a TV into the Clone programmer, you can set a master TV’s clock by copying the time from the Clone programmer.) The Clone Programmer can copy the current time to both a master TV and to the Clone’s internal clock; accurate to within one minute. (Another reason that the Clone programmer should be equipped with fresh,
Since the Clone Programmer’s time cannot be set directly, the current time needs to be copied from a Zenith/LG TV equipped with M.P.I. input capability.
After the time is copied to the Clone programmer, the current time can then be transferred to another TV. (This can be a master TV, or another TV which has already had the features set up.)
This menu should appear by itself after the
LT2002 is connected to the TV MPI port.
CLONE SELECTION MENU
(1)LEARN FROM TV
(2)TEACH TO TV
(3)SET CLONE CLOCK FROM TV
(4)SET TV CLOCK FROM CLONE
(5)DISPLAY TV SETUP
(6)DISPLAY CLONE SETUP
This menu should appear after any key is pressed on the Installer remote.
LT2002 Clone Programmer Communication Problems
•A slow flashing green light indicates there are communica- tion problems between the TV and the LT2002 clone program- mer. If this is the case, check for a damaged cable, poor con- tacts, or other connection troubles.
•If the status indicator is red, the programmer batteries are low and should be replaced. Install 4
P A G E 3 2 |