Installation and Setup
Setting up the Player
The picture and sound of a nearby TV, VCR, or radio may be distorted during playback. If this occurs, position the player away from the TV, VCR, or radio, or turn off the unit after removing the disc.
DVD Player Connections
Depending on your TV and other equipment there are various ways you can connect the player. Please refer to the manuals of your TV, stereo system or other devices as necessary for additional connection information.
Rear of TV
|
|
|
|
| SCART INPUT |
| COMPONENT VIDEO / | AUDIO INPUT | VIDEO | ||
PROGRESSIVE SCAN INPUT |
|
| INPUT | ||
Pr | Pb | Y | R | L |
|
CA VT
Rear of DVD player
Caution:
You must set the TV Output Select option on the setup menu to use COMPONENT VIDEO OUT/PROGRESSIVE SCAN jack or SCART’s RGB signal. (Refer to page 11.)
Video and Audio Connections to Your TV
Make sure the DVD player is connected directly to the TV and not to a VCR, otherwise the DVD image could be distorted by the copy protection system.
SCART connection – Connect the TO TV scart jack on the unit to the corresponding in jacks on the TV using the scart cable (T).
Video – Connect the VIDEO OUT jack on the DVD player to the video in jack on the TV using the video cable (V)
Audio – Connect the left and right AUDIO OUT jacks of the DVD Player to the audio left and right IN jacks on the TV (A) using the audio cables.
Do not connect the DVD Player’s AUDIO OUT jack to the phone in jack (record deck) of your audio system.
Component Video – Connect the COMPONENT VIDEO OUT/PROGRESSIVE SCAN jacks on the DVD Player to the corresponding in jacks on the TV using an Y Pb Pr cable (C).
Progressive Scan
•If your television is a
•Set the Progressive to “On” on the setup menu for progressive signal, see page 11.
•Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack).
8