Basic Operations
POWER
To turn the unit ON and OFF:
1.Plug the power cord into an active AC power outlet.
2.Press the POWER button (on the remote controller) to turn on.
The monitor’s POWER/STANDBY indicator will light up(green) when the unit is on.
3.Press the POWER button (on the remote controller or the unit) to turn off.
The monitor’s POWER/STANDBY indicator turns red and the standby mode is set (only when turning off the unit with the remote control).
VOLUME
To adjust the volume:
1.Press and hold the VOLUME ▲ button (on the remote controller or the unit) to increase to the desired level.
2.Press and hold the VOLUME ▼ button (on the remote controller or the unit) to decrease to the desired level.
MUTE
To cancel the sound:
Press the MUTE button on the remote controller to cancel
sound; press again to restore.
DISPLAY
To check the settings:
1.The screen changes each time the DISPLAY button is pressed.
2.If the button is not pressed for approximately three sec- onds, the menu turns off.
VISUAL CONTROL
TO adjust the picture's contrast:
1, Press and hold the CONTRAST ▲ button for higher contrast.
2, Press and hold the CONTRAST ▼ button for lower contrast.
TO adjust the picture's brightness:
1, Press and hold the BRIGHT ▲ button for a brighter picture.
2, Press and hold the BRIGHT ▼ button for a darker pic- ture.
TO adjust the picture's color:
1, Press and hold the COLOR ▲ button for more color saturation.
2, Press and hold the COLOR ▼ button for less color satu- ration.
TO adjust the picture's tint (NTSC only):
1, Press and hold the TINT ▲ button for a greener tint. 2, Press and hold the TINT ▼ button for a redder tint.
TO adjust the picture's sharpness:
1, Press and hold the SHARPNESS ▲ button for a sharper picture.
2, Press and hold the SHARPNESS ▼ button for a softer picture.
*If no key operation is made within five seconds, the OSM display will disappear.
13