Replacing CD-ROM Drives

Address the TEAC drives for their location.

DTS-6D	Drive A:		DTS-6 Termination programmed
TEAC 16X	Drive A:	Jumper 2, 4, 6	Jumper 2, 4, 6	on Pin 4, that should be
	Drive B:	Jumper 0, 2, 4, 6	Jumper 0, 2, 6	removed to activate.
	Drive C: Jumper 0, 1, 6
TEAC 32X	Drive A:	Jumper 2	Jumper 2	Termination programmed
	Drive B:	Jumper 0, 2	Jumper 0, 2, 5	on Pin 5, that should be
	Drive C:	Jumper 0, 1, 5		added to activate.

8.Verify the “AQRM” chip is installed in the Acqutec ROM board. The AQRM chip must be installed correctly.

9.Verify the Acqutec ROM and Adaptec SCSI boards are addressed as shown on page 6.

10.Install the Acqutec ROM and Adaptec SCSI boards. These boards must be used. See the “DTS- 6D” diagram for board orientation. It will be the same for the DTS-6 or DTS-6D. Use the saved screw from the old SCSI board and a new #4 screw to mount both boards to player’s chassis.

NOTE: Bottom metal tab must be cut off for boards to fit correctly into unit.

11.Connect SCSI cable to Adaptec SCSI board. Check orientation of pin 1.

12.Apply power to player. Test the player by loading in the DTS DS1 Setup Disc. The player should boot-up and automatically play the disc. Be sure the DIGITAL and CD-ROM L.E.D.s light. Check each drive. All drives must be the same manufacturer.

13.Re-install the top cover and re-install the player into the sound rack.

REPLACING CD-ROM DRIVES

DTS-6D

TEAC 16X