CHAPTER 3: Setup and Installation.
3.4.2 Skew Compensation Settings
The XR2000 receiver is available with an optional skew compensation module to adjust for signal timing differences due to differing pair lengths within the CAT5 cable. Using the delay signals, skew may be compensated from 2 to 65 nanoseconds in 2 nanosecond increments on each individual color pair.
If skew compensation is required, but the skew comp module is not installed, call for technical assistance.
An image file is available to assist in these settings (see Section 3.4.1 for details). See Figure
1.To adjust individual colors, press the EQ/Skew knob until the desired color LED is on for the RGB Skew LEDs to the left of the cable length LEDs. The R LED is for the Red color channel, G LED is for green and the B LED is for blue.
2.Using the image utility, turn knob to add/subtract delay timing until a single vertically aligned line of red, green, blue is obtained.
3.When complete press EQ/Skew knob until RGB LEDs are all off.
Not all colors will have the same delay settings.
Figure 3-5: Image Adjustment Utility—Skew
119