Magenta setup guide Appendix B. XR2000 Configuration Settings

Page 16

MAGENTA MULTIVIEW™ SERIES

Appendix B. XR2000 Configuration Settings

Note: XR2000 receivers are typically pre-configured at time of order and will have factory configuration indicated on the bottom of the unit.

The factory configuration may be changed or checked by using the following jumper location diagram as well as Table B-1 for jumper settings.

Figure B-1. XR2000 Jumper locations.

JP13 controls sync clamping circuitry and has 3 settings depending on the video signal in use:

RGBHV computer video with separate horizontal and vertical sync == JP13 1-2 Non RGBHV computer video, component RGB/YUV, S-video, composite video or RGsB video == JP13 2-3

Auto sense video mode == JP13 non-jumpered.

146

Image 16

Contents MultiView Magenta ResearchBy Magenta Research All rights reserved European Union Declaration of Conformity Contents Specifications Introduction OverviewEquipment You May Also Need Compatible CablingCabling Considerations Data Mode ConfigurationMaking the Connections Connections on the SINGLE-PORT VGA/AUDIO Connections on the SINGLE-PORT VGA SA and SAP SA & SAP connectionsVideo Adjustment Cable Distance Compensation SettingsSkew Compensation Settings Image Adjustment Utility-SkewTroubleshooting Common ProblemsProblem Solution113 Appendix A. Cabling Pinouts Table A-1. HD15 video connectorTable A-2. Phoenix Connection Table A-3. DB9 Male Serial connector Table A-4. T568B CAT5 pinoutAppendix B. XR2000 Configuration Settings 157 Appendix C. Setting Sync Mode Jumper Setting JP10 JP11 JP12Appendix D. Skew Module Figure D-1Appendix E. Rackmounting Units Figure E-1. Receiver Mounting BracketAppendix F. Pollable Serial Mode Appendix F. Pollable Serial Mode Address Chart Appendix F. Pollable Serial Mode Address Chart Cont Magenta Research