Harman-Kardon AVR45 owner manual System Configuration

System Configuration

18

When LARGE is selected, a full- range output will be sent to the front left and right outputs, and NO low-frequency signals will be sent to the subwoofer output.

5.When you have completed your selection for the front channel, press the Set button i÷, and then press the Ú/ Û buttons gon the remote or the Selector buttons ü on the front panel to change the dis- play to CEN SPEAKER.

6.Press the Set button i÷again, and use the Ú/ Û buttons gon the remote, or the Selector buttons üon the front panel, to select the option that best describes your system based on the speaker definitions shown above.

When CEN SP SMALL is selected, low-frequency center channel sounds will be sent to the subwoofer output only. Note that if you choose this option and there is no subwoofer connected, you will not hear any low-frequency sounds from the center channel speaker.

When CEN SP LARGE is selected, a full-range output will be sent to the center speaker output, and NO center channel signal will be sent to the subwoofer output.

When CEN SP NONE is selected, no signals will be sent to the center channel output. The receiver will operate in a “phantom” center channel mode and center channel information will be sent to the left and right front channel outputs.

7.When you have completed your selection for the center channel, press the Set button i÷, and then press the Ú/ Û buttons gon the remote or the Selector buttons ü on the front panel to change the display to SUR SPEAKER.

8.Press the Set button i÷again, and then use the Ú/ Û buttons g on the remote or the Selector buttons üon the front panel to select the option that best describes your system based on the speaker definitions shown above.

When SUR SP SMALL is selected, low-frequency surround channel sounds will be sent to the subwoofer output only. Note that if you choose this option and there is no subwoofer connected, you will not hear any low-frequency sounds from the surround speaker.

When SUR SP LARGE is selected, a full-range output will be sent to the surround channel outputs, and NO surround channel signals will be sent to the subwoofer output.

When SUR SP NONE is selected, surround sound information will be split between the front left and front right outputs. Note that for optimal performance when no surround speakers are in use, the Dolby 3 Stereo mode should be used instead of Dolby Pro Logic.

9.When you have completed your selection for the surround channel, press the Set button i÷, and then press the Ú/ Û buttons gon the remote or the Selector buttons ü on the front panel to change the display to SÐW SPEAKER.

10.Press the Set button i÷, and then press the Ú/ Û buttons gon the remote or the Selector buttons ü on the front panel to select the option that best describes your system.

Select S-W SP ON if a subwoofer is connected to your system.

Select S-W SP OFF if a subwoofer is NOT connected to your system. Note that when no subwoofer is selected, low-frequency sounds below 100Hz will be sent to the front left/right speakers, provided that the selection in step 4, above, has been set to LARGE. Otherwise, no low-frequency sounds will be heard. This option is not available when the front, center or surround speakers are set to SMALL.