Hitachi 55HDX99 Remote for VCR/PVR Functions, Precoded VCR/PVR Buttons, MY VCR/PVR Code is

The Remote for VCR/PVR Functions

Operating the precoded function for your VCR/PVR (Personal Video Recorder).

This remote is designed to operate different types of VCRs/PVRs. You must first program the remote to match the remote system of your VCR/PVR (refer to

pages 42-43 for pre-codes).

1.Turn ON your VCR/PVR.

2.Aim the remote control at the front of your VCR/PVR.

3.To switch to VCR/PVR pre-coded mode, use the

SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4.	Hold down the ENT button on the remote and enter
	the four digit preset code that matches your
	VCR/PVR, as shown on pages 42-43. Release the
	ENT button. The indicator light will flash 3 times if
	the code was accepted.
5.	Aim the remote at the VCR/PVR and press the

￿

￿

+

-

￿

￿

￿

￿

The Remote

POWER button. The remote will turn off your PVR

when the correct four digit preset code is entered.

When this occurs, the remote control is

programmed for your VCR/PVR. If the VCR/PVR

does not turn off, try a different four digit preset

code.

6. The remote will now control your VCR/PVR.

NOTE: 1. If your VCR/PVR cannot be operated after performing the above procedures, your VCR/PVR code has not been precoded into the remote.

2.In the unlikely event that your VCR/PVR cannot be operated after performing the above procedures, please consult your VCR/PVR operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

￿PRECODED VCR/PVR Buttons

These buttons transmit the chosen precoded VCR/PVR codes.

￿EXCLUSIVE TV Buttons

These buttons are for operating the TV.

/

￿

￿

MY VCR/PVR CODE IS:

NOTE: Refer to instruction manual of the VCR/PVR for operation of the buttons exclusively for the VCR/PVR.

Control

39