Hitachi 42HDT79 Remote Control for Set-Top-Box/Satellite Receiver Functions, SET-TOP-BOX Code is

The Remote Control for Set-Top-Box/Satellite Receiver Functions

Operating the precoded function for your set-top- box/satellite receiver.

This remote is designed to operate different types of set-top-box/satellite systems. You must first program the remote to match the remote system of your set-

top-box/satellite systems (refer to pages 42-43 for pre-

codes).

1.Turn ON your set-top-box/satellite systems.

2.Aim the remote control at the front of your set-top- box/satellite systems.

3.To switch to set-top-box/satellite (STB) pre-coded

mode, use the SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4. Hold down the ENT button on the remote and enter

the four digit preset code that matches your set-

top-box/satellite receiver as shown on page 42-43.

Release the ENT button. The indicator light will

flash 3 times if the code was accepted.

￿

￿

+

-

￿

￿

￿

The Remote

5. Aim the remote at the set-top-box/satellite receiver

and press the POWER button. The remote will turn

off your set-top-box/satellite receiver when the

correct four digit preset code is entered. When this

occurs, the remote control is programmed for your

set-top-box/satellite receiver. If the set-top-

box/satellite receiver does not turn off, try a

different four digit preset code.

6. The remote will now control your set-top-

box/satellite receiver.

NOTE: 1. If your set-top-box/satellite receiver cannot be operated after performing the above procedures, your set-top-box/ satellite receiver code has not been precoded into the remote.

2.In the unlikely event that your set-top- box/satellite receiver cannot be operated after performing the above procedures, please consult your set-top-box/satellite receiver operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

￿PRECODED SET-TOP-BOX/SATELLITE RECEIVER buttons

These buttons transmit the chosen pre-coded set- top-box/satellite codes.

￿EXCLUSIVE TV buttons

These buttons are for operating the TV.

/

￿￿

￿

MY Satellite RECEIVER/

SET-TOP-BOX CODE IS:

NOTE: Refer to instruction manual of the Set-Top- Box/Satellite Receiver for operation of the buttons exclusively for the Set-Top- Box/Satellite Receiver.

Control

37