Hitachi 42HDX62A, 55HDX62 Appendix E, Information and press the Select button

Rear Panel Connections

Appendix E

After the CableCARD has been successfully installed, a CableCARD Information menu appears in the SETUP menu of the On-Screen Display.

Follow the instructions below to access the CableCARD Information menu.

1.Press the MENU button on the Remote Control to access the Main Menu screen.

Video

Audio

TV Guide On Screen

Channel Manager

Locks

Timers

Setup

Move SEL Select

2.	Use the CURSOR PAD		to highlight SETUP in
	the Main Menu and press the SELECT button.
3.	Use the CURSOR PAD		to highlight CableCARD
	Information and press the SELECT button.
		Setup
		Menu Preference
		Screen Saver
		Set The Inputs
		Set AV NET
		Set Closed Captions
		Set Monitor Out
		CableCARD Information
		Upgrades
		Set Stand-By Mode
		Move SEL Select

4.To view the CableCARD ID and Host ID, use the CURSOR PAD to highlight CableCARD Info and press the SELECT button.

Setup

CableCARD Information

Select the button below to acess

CableCARD ID and Host ID.

CableCARD Info.

Select the button below to access

CableCARD and Host Diagnostics.

Diagnostics Info.

Move SEL Return

In order to start cable service for this device, please contact your cable provider

CableCARD(tm): 123-456-789-1

Host: 123-456-789-1

Data: 123-456-789-1

Unit Address: 123-456-789-1

Press EXIT to return

THINGS TO CHECK WHEN USING THE CableCARD / CableCARD Services

1.Check that the CableCARD is properly inserted in the CableCARD slot.

2.Remove the CableCARD by pressing the eject button and pull the CableCARD straight out.

3.Visually inspect the CableCARD to ensure all pin- holes are in good condition, with none blocked or damaged.

4.Make sure the CableCARD is re-inserted in the correct direction, then slowly push until it is fully seated in the slot.

5.When the CableCARD is installed, note all screen messages that appear (“CableCARD Installed”, “Acquiring Data”, “CableCARD is not Installed”). If the “CableCARD Installed” message does not appear when card is installed, check the TV’s card slot and CableCARD pins for obstructions or damage.

6.If problems still remain, please contact your Cable Service Provider.

NOTES:

1.When a CableCARD is installed, Auto Channel scan will not be needed because the channel list is automatically loaded to the TV's channel memory.

2.The TV will take several seconds to detect and recognize the presence of the CableCARD. This process must be completed before any CableCARD information or Channel listings is accessed.

First time use

NOTE: The Diagnostics Info. window is for

Service use only.

13