Hitachi 42HDX62A Remote Control for DVD Functions, Precoded DVD Buttons, MY DVD Player Code is

Page 37

The Remote Control for DVD Functions

Operating the precoded function for your DVD player.

This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player (refer to pages 41-42 for pre-codes).

1.Turn ON your DVD player.

2.Aim the remote control at the front of your DVD player.

3.To switch to DVD pre-coded mode, use the

SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4.Hold down the ENT button on the remote and enter the four digit preset code that matches your DVD player, as shown on pages 41-42. Release the ENT button. The indicator light will flash 3 times if the code was accepted.

5.Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different four digit preset code.

6.The remote will now control your DVD player.

7.You will need to set the display type of your DVD player to 16:9 widescreen.

NOTE: 1. If your DVD player cannot be operated after performing the above procedures, your DVD player code has not been precoded into the remote.

2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

PRECODED DVD Buttons

These buttons transmit the chosen precoded DVD codes.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

/

MY DVD PLAYER CODE IS:

NOTE: Refer to instruction manual of the DVD Player for operation of the buttons exclusively for the DVD Player.

The Remote Control

37

Image 37

Contents Plasma Television Read Before Operating Equipment Important Safety InstructionsFor More INFORMATION, Call 1-800-HITACHI Remote Control Battery Installation Replacement AccessoriesFor U.S. models Connect Power Swivel Cable How To Set Up Your New Hitachi Plasma TelevisionAntenna LocationMinimum 10’ 15’Viewing Antenna Connections to Rear Jack PanelHook-up Cables and Connectors Mode Indicator Quick Reference Remote Control Buttons and FunctionsFront/Rear/Side Panel Controls Remote Control sensor Power light indicatorLearning AV NET sensor Side Input Jacks for InputIR Blaster/G-LINK Rear Panel ConnectionsMonitor OUT & HI-FI Audio OUT To Power Swivel Connector Upgrade CardSubwoofer Out IEEE1394 DV InputInformation and press the Select button Appendix EBefore Operating External Video Source Connecting External Video SourcesDVI Hdmi Macrovision Notes Tips on Rear Panel ConnectionsConnecting a Video and Stereo Audio Source to INPUT1 INPUT5 DVI to Hdmi Input Hdmi inputSee page 16 for tips on Rear Panel Connections Digital VCR D-VHS Connecting AN External Audio Amplifier Connecting External Audio/Video DevicesConnecting Monitor OUT VCR Output C B P R/C R R Automatic Mode Default mode Remote ControlHow to Use the Remote to Control Your TV Standard Aspect buttonExpanded ZOOM1/ZOOM2AIR ANALOG/DIGITAL ChannelsPhoto Input Cursor PADRotate When an IEEE1394 device is connected When an IEEE1394 device is not connectedIEEE1394 Last Channel Last CH button Volume VOL WHEEL, Mute buttonChannel CH WHEEL/CHANNEL Selector buttons Dash buttonPIP button Picture-in-Picture PIPSplit Mode PICTURE-IN-PICTURE PIP Mode PICTURE-IN-PICTURESurf Mode PICTURE-IN-PICTURE PIPMain Freeze Split FreezeStrobe Freeze Operating the precoded function for your cable box Remote Control for Cable Box FunctionsPrecoded Cable BOX buttons Exclusive TV buttonsPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons Remote Control for Set-Top-Box/Satellite Receiver FunctionsMY Satellite Receiver SET-TOP-BOX Code isOperating the precoded function for your DVD player Remote Control for DVD FunctionsPrecoded DVD Buttons MY DVD Player Code isPrecoded VCR/PVR Buttons Remote for VCR/PVR FunctionsMY VCR/PVR Code is Operating the precoded function for your Audio component Remote Control for Additional Audio EquipmentPrecoded Audio Buttons MY Audio Component Code isInput Access How to Use the ENT ButtonVCR Brand Code Remote Control CodesSET TOP BOX BRAND..CODE Simple Remote Control Video On-Screen DisplayTV Guide On Screen Video Use the Cursor PAD Auto Color Color DecodingWhite Balance AspectSet Black Side Panel Reset Video SettingsSRS AudioBBE DRC Setup Procedure To Setup the TV Guide On Screen SystemTV Guide On Screen TV Guide On Screen TV Guide On Screen TV Guide On Screen TV Guide On Screen Using the TV Guide On Screen System Guide Navigating the TV Guide on Screen SystemName Description TV Guide On Screen IconsCancel GO to Service BARListings Tune to Channel / Watch NOWExample Category Search Movies SearchTo Edit or Delete a keyword Example Keyword SearchEdit Search Delete SearchResume RecordingsPlay from Beginning Delete EpisodeWatch NOW/TUNE to Channel ScheduleDelete Recording Edit RecordingRecording Conflict How to RemindRecording Notification Banner How to set a reminder Reminder Notification Banner SetupRemind Conflict Remind conflict message will appear if Select these optionsChange Channel Display Change System SettingsGeneral Default Options Change Default OptionsRecord Defaults Remind DefaultsIR Defaults Start or Reset option Signal MeterChannel Manager Auto Channel ScanWhich are your Favorite FAV Channels Channel ListLocks Change Access CodeMotion Picture Ratings Table Movie RatingsUse the Cursor PAD , or Channel TV RatingsTV Parental Guide Ratings Table Canadian Ratings English Table Canadian Ratings EngCanadian Ratings French Chart Set The Clock TimersSet Day/Night Timer Set Sleep TimerUse the Cursor Pads to select DAY Mode on Menu Preference SetupSet the Language Screen Saver Picture’s Movement Automatic Power Saving Image PowerSet the Menu Background Screen SaverRemote AutoOff Set AV NetPress the Select button to start the Setup Wizard AV NET Setup Wizard Example A/V Receiver SetupAV Net Setup Wizard Device Settings AV NET Setup Wizard Example DVD SetupLearning Mode Learning Mode Example A/V Receiver SetupUse the Cursor PAD To select Other from brand name choices AV Net Setup Wizard A/V Receiver Setup Learning Mode Example CUSTOM/DVD 3 SetupPower Menu Select Exit Setup Set Closed Caption Caption ModeCaption Display Analog CaptionsMonitor Set Monitor OutTV Tuner Out FixedUpgrade NOW UpgradesInsert MMC Card Power Swivel Set Stand-By ModeTroubleshooting Equipment Care and TroubleshootingSwitch ON/OFF Switch once Do notReception Problems Troubleshooting What do the frequencies for Record and Remind mean? Is Help available in the Guide? If so, how do I find it?How can I look for a specific show in the Guide? Agency Regulatory Information Useful InfoFeatures Features and SpecificationsSet Dimensions Home Electronics Division HitachiDigital Media Division Canada 1-800-HITACHIEND User License Agreement for Hitachi DTV Software End User License Agreement for Hitachi DTV SoftwareImage Input Type Format Aspect Video ID Auto Aspect AppendixesHdmi IndexQR64866