Hitachi L26D204 manual Quick guide for menu operation, Example Select Language

DISPLAY

Press DISPLAY to display the current information on the screen.

When the TV receives a digital signal, the digital information will appear.

			Sleep Timer
	62-1	HDTV Moving Picture1
	CH-1			Off
	Digital	Air		English
	No Program Information is available
	Full
	1080i
• Channel number			• Station name
• Channel label (if preset)			•	Broadcast program name
•	V-Chip rating		•	Signal type
•	Sleep timer		•	Audio language
•	Program guide		•	Picture size
•	Resolution

When the TV receives an analog signal, the analog information will appear.

		Sleep Timer
	14
			Off
	Analog Cable
	Mono
	Full
	480i
•	Channel number	• Channel label (if preset)
•	V-Chip rating	•	Signal type
•	Sleep timer	•	Picture size
•	Audio information	•	Resolution
	(Stereo, SAP or Mono)

Press DISPLAY again to clear the call display.

NOTE:

• After a few seconds, DISPLAY screen will return to normal TV- operation automatically.

LAST CH

This button allows you to go back to the last channel selected by pressing LAST CH. Press LAST CH again to return to the last channel you were watching.

MUTE

Press MUTE to switch off the sound. The TV’s sound will be silenced and “Mute” will appear on the screen. The sound can be switched back on by pressing this button again or the VOL + or –.

SLEEP

To set the TV to turn off after a preset amount of time, press SLEEP on the remote control. The clock will count up 10 minutes for each press of the SLEEP button (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the sleep timer is programmed, the display will appear briefly every ten minutes to remind you that the sleep timer is op- erating. To confirm the sleep timer setting, press SLEEP and the remaining time will be displayed for a few seconds. To cancel the sleep timer, press SLEEP repeatedly until the display turns to Off.

Quick guide for menu operation

Example: Select Language.
1	Press INPUT to select TV mode.
2	Press SETUP/TV MENU. The TV menu screen will appear.
		Main Menu
		Video	>>
		Audio
		Channel
		Locks
		Setup
3	: Move		ENTER:Select
	Press ▲ or ▼ to select “Setup”, then press ▶ or ENTER.
	Press ▲ or ▼ to select “Menu Language”, then press ◀ / ▶ to
4 select the desired language.
	…on the following pages the menu can be called in the same
5	way as here.
	Press EXIT to return to the normal screen.

NOTE:

• If no buttons are pressed for more than about 60 seconds, the menu screen will return to normal operation automatically.

16

54H0321A_eng.indd 16

5/4/10 3:44:35 PM