Extron electronic MLC 52 manual Assign Commands To Buttons window with PC button selected

Assign Commands To Buttons window with PC button selected

To add a command to a button,

a. Click on the screen button that you want to program. A yellow box appears around it, and its name is displayed in the Selected Button field. In the illustration above, the button labeled “PC” was selected.

b. In the Select Driver Command field, click on the command function you want the selected button to execute. In the illustration, RGB1 was selected.

c. Click Add Command. The selected command appears in the next available slot in the Assigned Driver Commands field, replacing <EMPTY>. See the example at right.

d. If you want to add another command to the same button, repeat steps 5b and 5c. You can assign up to four commands to a button.

e. If you want to assign commands to another button, repeat steps 5a through 5d for each button that you want to program.

If you do not want to add a command to a button at this time, click Skip to go to the next screen.

To remove a command from a button,

a. Click on the button from which you want to remove the command.

b. In the Assigned Driver Commands field, click on the command function that you want to remove.

c. Click Remove Command. The command name is replaced by <EMPTY> in the Assigned Driver Commands field.

MLC 52 Series MediaLink Controllers • Serial Communication 5-15